86652A
1.INSTALL SKID CONTROL BUZZER ASSEMBLY (for LHD)
Connect the buzzer connector.
Securely connect the connector.
Attach the clamp to install the buzzer.
Securely insert the clamp into the bracket.
If the buzzer is dropped, replace it.
86652A
2.INSTALL SKID CONTROL BUZZER ASSEMBLY (for RHD)
Connect the buzzer connector.
Securely connect the connector.
Attach the clamp to install the buzzer.
Securely insert the clamp into the bracket.
If the buzzer is dropped, replace it.
55446A
3.INSTALL NO. 1 SWITCH HOLE BASE
55432D
4.INSTALL LOWER NO. 1 INSTRUMENT PANEL FINISH PANEL
62112
5.INSTALL COWL SIDE TRIM BOARD
55606
6.INSTALL NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY
67914B
7.INSTALL FRONT DOOR SCUFF PLATE
28800
8.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).