Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › SKID CONTROL BUZZER › 2014.08–2015.08
RM2660E _54 Brake _052819 BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS _0255410 SKID CONTROL BUZZER A

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS  SKID CONTROL BUZZER  REMOVAL  


PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).


Hide 28800 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).


Hide 67914B 3.REMOVE FRONT DOOR SCUFF PLATE

Hide 55606 4.REMOVE NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY

Hide 55432D 6.REMOVE LOWER NO. 1 INSTRUMENT PANEL FINISH PANEL

Hide 86652A 8.REMOVE SKID CONTROL BUZZER ASSEMBLY (for LHD)

a.
C170922

Detach the clamp and remove the buzzer.


b.

Disconnect the buzzer connector.


Hide 86652A 9.REMOVE SKID CONTROL BUZZER ASSEMBLY (for RHD)

a.
C172844

Detach the clamp and remove the buzzer.


b.

Disconnect the buzzer connector.