DTC output mode is set by connecting terminals TC and CG of the DLC3.
The DTCs are output by the blinking of the ABS warning light and slip indicator light.
When each warning light stays blinking, a ground short in the wiring of terminal TC of the DLC3 or an internal ground short in each ECU is suspected.
After replacing the master cylinder solenoid, perform zero point calibration and store the system information (See page Brake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>VEHICLE STABILITY CONTROL SYSTEM>CALIBRATION).
Turn the ignition switch to ON.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
|---|---|---|
| E22-13 (TC) - E22-4 (CG) | Ignition switch ON | 11 to 14 V |
| *1 | DLC3 |
OK
NG
A
B
C
A
B
C
Turn the ignition switch off.
for LHD:
Disconnect the A38 ECM connector.
for RHD:
Disconnect the A52 ECM connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| A38-16 (TC) - E22-13 (TC) | Always | Below 1 Ω |
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| A52-16 (TC) - E22-13 (TC) | Always | Below 1 Ω |
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| A38-27 (TC) - E22-13 (TC) | Always | Below 1 Ω |
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| A52-27 (TC) - E22-13 (TC) | Always | Below 1 Ω |
OK
NG
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| E22-4 (CG) - Body ground | Always | Below 1 Ω |
| *1 | DLC3 |
OK
NG
Using SST, connect terminals TC and CG of the DLC3.
Check that the malfunction indicator lamp is blinking.
| Result | Proceed to |
|---|---|
| MIL is blinking | A |
| MIL is not blinking | B |
| *1 | DLC3 |
A
B
Turn the ignition switch off.
Connect the GTS to the DLC3.
Turn the ignition switch to ON and the GTS on.
Check for DTCs (for LHD: See page Power Source / Network>NETWORKING>CAN COMMUNICATION SYSTEM(for LHD)>DIAGNOSIS SYSTEM, for RHD: See page Power Source / Network>NETWORKING>CAN COMMUNICATION SYSTEM(for RHD)>DIAGNOSIS SYSTEM).
| Result | Proceed to |
|---|---|
| CAN system DTC is not output (for LHD) | A |
| CAN system DTC is not output (for RHD) | B |
| CAN system DTC is output (for LHD) | C |
| CAN system DTC is output (for RHD) | D |
A
B
C
D