The skid control ECU (master cylinder solenoid) measures the speed of each wheel by receiving signals from the speed sensor. These signals are used for recognizing that all 4 wheels are operating properly. Therefore, all wheel signals must be equal.
| DTC Code | DTC Detection Condition | Trouble Area |
|---|---|---|
| C1337 | Either condition is met:
·
The diameter of the 2 front wheels and 2 rear wheels is different. ·
There is a wheel speed sensor fault. |
·
Speed sensor ·
Speed sensor rotor ·
Speed sensor circuit ·
Tire size |
After replacing the master cylinder solenoid, perform zero point calibration and store the system information (See page Brake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>VEHICLE STABILITY CONTROL SYSTEM>CALIBRATION).
When DTCs C1401 to C1416 are output with DTC C1337, inspect and repair the trouble areas indicated by DTCs C1401 to C1416 first (See page Brake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>VEHICLE STABILITY CONTROL SYSTEM>DIAGNOSTIC TROUBLE CODE CHART).
Check tire size and condition of all 4 wheels.
Condition of all 4 wheels is normal and tire size is same.
OK
NG
Clear the DTCs (See page Brake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>VEHICLE STABILITY CONTROL SYSTEM>DTC CHECK / CLEAR).
Turn the ignition switch off.
Drive the vehicle at a speed of approximately 32 km/h (20 mph) or more for 60 seconds or more.
Check if the same DTCs are output (See page Brake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>VEHICLE STABILITY CONTROL SYSTEM>DTC CHECK / CLEAR).
Reinstall the sensors, connectors, etc. and restore the previous vehicle conditions before rechecking for DTCs.
| Result | Proceed to |
|---|---|
| DTC is not output | A |
| DTC is output (for LHD) | B |
| DTC is output (for RHD) | C |
A
(See pageGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING)
B
C