Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › VEHICLE STABILITY CONTROL SYSTEM › from 2015.08
RM2660E _54 Brake _052819 BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS _0255415 VEHICLE STABILITY CONTROL SYSTEM C

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS  VEHICLE STABILITY CONTROL SYSTEM  C1417  High Power Supply Voltage Malfunction  


DESCRIPTION

If a malfunction is detected in the power supply circuit, the skid control ECU (master cylinder solenoid) stores this DTC and the fail-safe function prohibits ABS/VSC/TRC operation.

This DTC is stored when the IG1 terminal voltage deviates from the DTC detection condition due to a malfunction in the power supply or charging circuit such as the battery or generator circuit, etc.

This DTC is cleared when the IG1 terminal voltage returns to normal.

DTC Code DTC Detection Condition Trouble Area
C1417 The IG1 terminal voltage is 17.4 V or higher for 0.8 seconds or more.
·

Charging system

·

Power source circuit

·

Internal power supply circuit of the skid control ECU (master cylinder solenoid)



CAUTION / NOTICE / HINT

NOTICE:

After replacing the master cylinder solenoid, perform zero point calibration and store the system information (See page Brake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>VEHICLE STABILITY CONTROL SYSTEM>CALIBRATION).


PROCEDURE

1.CHECK HARNESS AND CONNECTOR (IG1 TERMINAL)
a.

Disconnect the skid control ECU (master cylinder solenoid) connector.


b.
U156221E03
2.635,1.563 2.635,1.865 false 0.167,0.115 0.479,0.385 0.313,0.271 10 false *a 2.542,1.875 2.823,2.052 0.281,0.177 10 false IG1 0.188,0.708 0.458,0.875 0.271,0.167 10 false A24

Measure the voltage according to the value(s) in the table below.

Standard Voltage:
Tester Connection Condition Specified Condition
A24-46 (IG1) - Body ground Ignition switch ON
(Engine running)
11 to 14 V


Text in Illustration
*a Front view of wire harness connector
(to Skid Control ECU [Master Cylinder Solenoid])

Result
Result Proceed to
OK A
NG (for 1VD-FTV) B
NG (for 1UR-FE) C
NG (for 1GR-FE) C
NG (for 3UR-FE) D



A

2.RECONFIRM DTC

B

C

D

E

2.RECONFIRM DTC

b.

Turn the ignition switch off.


c.

Check if the same DTC is output (See page Brake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>VEHICLE STABILITY CONTROL SYSTEM>DTC CHECK / CLEAR).

Result
Result Proceed to
DTC is not output A
DTC is output (for LHD) B
DTC is output (for RHD) C



A

B

C