The skid control ECU (master cylinder solenoid) receives signals from the yaw rate sensor assembly via the CAN communication system.
The yaw rate sensor assembly has a built-in acceleration sensor.
| DTC Code | DTC Detection Condition | Trouble Area |
|---|---|---|
| C1442 | An invalid data signal is transmitted continuously from the acceleration sensor for 10 seconds or more. | Yaw rate sensor assembly |
| C1443 | An invalid data signal is transmitted continuously from the yaw rate sensor for 10 seconds or more. | Yaw rate sensor assembly |
After replacing the yaw rate sensor assembly, perform calibration (See page Brake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>VEHICLE STABILITY CONTROL SYSTEM>CALIBRATION).
Clear the DTCs (See page Brake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>VEHICLE STABILITY CONTROL SYSTEM>DTC CHECK / CLEAR).
Turn the ignition switch off.
Start the engine and idle it for 60 seconds, and then stop the engine.
Check if the same DTC is output (See page Brake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>VEHICLE STABILITY CONTROL SYSTEM>DTC CHECK / CLEAR).
| Result | Proceed to |
|---|---|
| DTC is output | A |
| DTC is not output | B |
A
(See pageBrake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>YAW RATE AND DECELERATION SENSOR (w/ VSC)>REMOVAL)
B
(See pageGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING)