Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › YAW RATE AND DECELERATION SENSOR (w/ VSC) › 2014.08–2015.08
RM2660E _54 Brake _052819 BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS _0255408 YAW RATE AND DECELERATION SENSOR(w/ VSC) A

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS  YAW RATE AND DECELERATION SENSOR(w/ VSC)  REMOVAL  


PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).


Hide 28800 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).


Hide 88520 3.REMOVE COOLING BOX ASSEMBLY (w/ Cool Box)

Hide 58901A 4.REMOVE REAR CONSOLE BOX SUB-ASSEMBLY (w/o Cool Box)

Hide 89183A 5.REMOVE YAW RATE SENSOR

a.

Disconnect the sensor connector, and then detach the clamp from the sensor bracket.

C177095E01
0.09,0.037 0.760,0.242 0.670,0.205 12 for LHD:

C170924E01
0.093,0.071 0.770,0.250 0.677,0.179 12 for RHD:


b.

Remove the 2 bolts and sensor.