Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › VEHICLE STABILITY CONTROL SYSTEM › from 2015.08
RM2660E _54 Brake _052819 BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS _0255415 VEHICLE STABILITY CONTROL SYSTEM C

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS  VEHICLE STABILITY CONTROL SYSTEM  C1257  Power Supply Drive Circuit  


DESCRIPTION

The motor relay (semiconductor relay) is built into the master cylinder solenoid and drives the pump motor based on a signal from the skid control ECU (master cylinder solenoid).

DTC Code DTC Detection Condition Trouble Area
C1257 There is an open in the motor system circuit (motor input circuit). Skid control ECU (Master cylinder solenoid)

CAUTION / NOTICE / HINT

NOTICE:

After replacing the master cylinder solenoid, perform zero point calibration and store the system information (See page Brake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>VEHICLE STABILITY CONTROL SYSTEM>CALIBRATION).


PROCEDURE

1.CHECK PUMP MOTOR OPERATION
a.

Turn the ignition switch off.


b.

Disconnect the A24 skid control ECU (master cylinder solenoid) connector.


c.

Depress the brake pedal more than 40 times.


d.

Turn the ignition switch to ON.


e.

Check pump motor operation.

OK:

Pump motor operates normally.


Result
Result Proceed to
OK A
NG (for LHD) B
NG (for RHD) C



A

2.RECONFIRM DTC

B

C

2.RECONFIRM DTC
a.

Turn the ignition switch off.


b.

Reconnect the A24 skid control ECU (master cylinder solenoid) connector.


c.

Turn the ignition switch to ON.



e.

Turn the ignition switch off.


f.

Check if the same DTC is output (See page Brake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>VEHICLE STABILITY CONTROL SYSTEM>DTC CHECK / CLEAR).

Result
Result Proceed to
DTC is not output A
DTC is output (for LHD) B
DTC is output (for RHD) C



A

B

C