Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › VEHICLE STABILITY CONTROL SYSTEM › from 2015.08
RM2660E _54 Brake _052819 BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS _0255415 VEHICLE STABILITY CONTROL SYSTEM C

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS  VEHICLE STABILITY CONTROL SYSTEM  C120A  ECU Initial Setting Incomplete  


DESCRIPTION

After replacing the skid control ECU (master cylinder solenoid) or clearing the system information stored in the skid control ECU (master cylinder solenoid), the system information must be stored in the skid control ECU (master cylinder solenoid) again. The system information is automatically stored in the skid control ECU (master cylinder solenoid) when the system enters test mode. If the system information is not stored in the skid control ECU (master cylinder solenoid), DTC C120A is stored.

DTC Code DTC Detection Condition Trouble Area
C120A The system information is not stored in the skid control ECU.
·

Calibration not performed

·

Skid control ECU (Master cylinder solenoid)



CAUTION / NOTICE / HINT

NOTICE:

After replacing the master cylinder solenoid, perform zero point calibration and store the system information (See page Brake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>VEHICLE STABILITY CONTROL SYSTEM>CALIBRATION).


PROCEDURE

1.PERFORM CALIBRATION
a.

Perform calibration (See page Brake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>VEHICLE STABILITY CONTROL SYSTEM>CALIBRATION).

NOTICE:

If a DTC is output after replacing the master cylinder solenoid, it is possible that calibration has not been performed or the zero point calibration data was not cleared when calibration was performed.




NEXT

2.CHECK DTC
2.CHECK DTC
a.

Check for DTCs (See page Brake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>VEHICLE STABILITY CONTROL SYSTEM>DTC CHECK / CLEAR).

Result
Result Proceed to
DTC is not output A
DTC is output (for LHD) B
DTC is output (for RHD) C



A

B

C