Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › VEHICLE STABILITY CONTROL SYSTEM › 2014.08–2015.08
RM2660E _54 Brake _052819 BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS _0255415 VEHICLE STABILITY CONTROL SYSTEM C

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS  VEHICLE STABILITY CONTROL SYSTEM  C1452  Accumulator Low Pressure  


DESCRIPTION

DTC Code DTC Detection Condition Trouble Area
C1452 After braking, the fluid pressure inside the accumulator is less than the threshold within 3.2 seconds.
·

Hydraulic circuit

·

Master cylinder solenoid (Accumulator pressure sensor)



CAUTION / NOTICE / HINT

NOTICE:

After replacing the master cylinder solenoid, perform zero point calibration and store the system information (See page Brake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>VEHICLE STABILITY CONTROL SYSTEM>CALIBRATION).


PROCEDURE

1.CUSTOMER PROBLEM ANALYSIS
a.

Check with the customer to determine if frequent braking has been performed.



NEXT

2.RECONFIRM DTC
2.RECONFIRM DTC

b.

Turn the ignition switch off.


c.

Depress the brake pedal more than 40 times.


d.

Turn the ignition switch to ON.


e.

Wait for 99 seconds.


f.

Check if the same DTC is output (See page Brake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>VEHICLE STABILITY CONTROL SYSTEM>DTC CHECK / CLEAR).

Result
Result Proceed to
DTC is output A
Frequent braking was not performed and DTC is not output B
Frequent braking was performed and DTC is not output C

HINT:

Excessive brake pedal operation results in abnormal accumulator pressure consumption. This is normal.




A

3.CHECK HYDRAULIC CIRCUIT

B

C

END

3.CHECK HYDRAULIC CIRCUIT
a.

Check the hydraulic circuit (See page Brake>BRAKE SYSTEM (OTHER)>BRAKE LINE>SYSTEM DIAGRAM).

OK:

Hydraulic circuit is normal (no leakage).




OK

4.READ VALUE USING GTS (ACCUMULATOR SENSOR)

NG

REPAIR HYDRAULIC CIRCUIT

4.READ VALUE USING GTS (ACCUMULATOR SENSOR)

A

5.RECONFIRM DTC

B

C