Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › ANTI-LOCK BRAKE SYSTEM › from 2015.08
RM2660E _54 Brake _052819 BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS _0255416 ANTI-LOCK BRAKE SYSTEM C

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS  ANTI-LOCK BRAKE SYSTEM  C1336  Zero Point Calibration of Acceleration Sensor Undone  


DESCRIPTION

The skid control ECU (master cylinder solenoid) receives signals from the deceleration sensor.

The DTCs are also stored when the calibration has not been completed.

DTC Code DTC Detection Condition Trouble Area
C1336 Zero point calibration of the deceleration sensor is incomplete.
·

Zero point calibration incomplete

·

Sensor installation

·

Deceleration sensor

·

Skid control ECU (Master cylinder solenoid)



WIRING DIAGRAM

Refer to DTCs C1243, C1245, C1381 and C1418 (See page Brake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>ANTI-LOCK BRAKE SYSTEM>C1243).

CAUTION / NOTICE / HINT

NOTICE:
·

After replacing the master cylinder solenoid, perform zero point calibration (See page Brake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>ANTI-LOCK BRAKE SYSTEM>CALIBRATION).

·

After replacing the deceleration sensor, perform zero point calibration (See page Brake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>ANTI-LOCK BRAKE SYSTEM>CALIBRATION).



PROCEDURE

1.PERFORM ZERO POINT CALIBRATION OF DECELERATION SENSOR
a.

Perform zero point calibration of the deceleration sensor (See page Brake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>ANTI-LOCK BRAKE SYSTEM>CALIBRATION).



NEXT

2.PERFORM TEST MODE (SIGNAL CHECK)
2.PERFORM TEST MODE (SIGNAL CHECK)
a.

Turn the ignition switch off.


b.

Perform the signal check in the Test Mode Procedure (See page Brake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>ANTI-LOCK BRAKE SYSTEM>TEST MODE PROCEDURE).

OK:

All test mode DTCs are cleared.




OK

END

NG

3.CHECK DECELERATION SENSOR INSTALLATION
3.CHECK DECELERATION SENSOR INSTALLATION
a.

Turn the ignition switch off.


b.

Check that the deceleration sensor has been installed properly (See page Brake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>DECELERATION SENSOR (w/ ABS)>INSTALLATION).

OK:

The sensor is tightened to the specified torque.

The sensor is not installed at an angle.




OK

4.READ VALUE USING GTS (DECELERATION SENSOR)

NG

4.READ VALUE USING GTS (DECELERATION SENSOR)
a.

Turn the ignition switch off.


b.

Connect the GTS to the DLC3.


c.

Turn the ignition switch to ON.


d.

Turn the GTS on.


e.

Enter the following menus: Chassis / ABS/VSC/TRC / Data List.

ABS/VSC/TRC
Tester Display Measurement Item/Range Normal Condition Diagnostic Note
Deceleration Sensor Deceleration sensor/ Min.: -18.525 m/s2, Max.: 18.387 m/s2 - Changes continuously during acceleration/deceleration.


f.

Check that the deceleration sensor output value is displayed on the GTS.

OK:

Deceleration value changes.


Result
Result Proceed to
NG A
OK (for LHD) B
OK (for RHD) C



A

B

C