Home › Steering › POWER ASSIST SYSTEMS › VANE PUMP (for 1GR-FE)
RM2660E _55 Steering _052824 POWER ASSIST SYSTEMS _0255439 VANE PUMP(for 1GR-FE) A

POWER ASSIST SYSTEMS  VANE PUMP(for 1GR-FE)  INSTALLATION  


PROCEDURE

Hide 44320 1.INSTALL VANE PUMP ASSEMBLY

a.
U166650

Install the vane pump with the 2 bolts.

Torque:
21 N*m (214 kgf*cm, 15 ft.*lbf)


Hide 44410 2.CONNECT PRESSURE FEED TUBE

C172778E02
2.365,0.969 2.198,0.969 2.198,0.969 1.677,1.542 true 2.396,0.885 3.083,1.271 0.688,0.385 10 true Pressure Feed Tube

a.

Install a new gasket to the pressure feed tube.


b.

Connect the pressure feed tube and install the union bolt.

Torque:
50 N*m (510 kgf*cm, 37 ft.*lbf)


Hide 44348A 3.CONNECT NO. 1 OIL RESERVOIR TO PUMP HOSE

a.
C172780

Connect the No.1 oil reservoir to pump hose to the vane pump assembly with the clip.


Hide 4.CONNECT POWER STEERING OIL PRESSURE SWITCH CONNECTOR

C172779

a.

Connect the connector.


b.

Attach the wire harness clamp to the bracket.


Hide 7.INSTALL FRONT WHEEL RH

Hide 8.ADD POWER STEERING FLUID

Hide 9.BLEED POWER STEERING FLUID

a.

Check the fluid level.


b.

Jack up the front of the vehicle and support it with stands.


c.

Turn the steering wheel.

i.

With the engine stopped, turn the wheel slowly from lock to lock several times.



d.

Lower the vehicle.


e.

Start the engine.


f.

Idle the engine for a few minutes.


g.

Turn the steering wheel.

i.

With the engine idling, turn the wheel left or right to the full lock position and keep it there for 2 to 3 seconds, then turn the wheel to the opposite full lock position and keep it there for 2 to 3 seconds. *1


ii.

Repeat *1 several times.

NOTICE:

For vehicles with VGRS, if the steering wheel is turned from lock to lock repeatedly, the system may stop operating and the amount of rotation before the steering wheel locks may increase due to operation of the overheating prevention function. When the system temperature drops, the system operation automatically returns to normal.




h.

Stop the engine.


i.
C124274E03
0.574,0.312 1.303,0.462 0.730,0.150 10 *a 1.919,0.312 2.841,0.462 0.922,0.150 10 *b

Check for foaming or emulsification.

Text in Illustration
*a Correct
*b Incorrect

If the system has to be bled twice because of foaming or emulsification, check for fluid leaks in the system.


j.

Check the fluid level.


Hide 10.INSPECT FOR POWER STEERING FLUID LEAK

Hide 11.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).