Home › Steering › POWER ASSIST SYSTEMS › VANE PUMP (for 1GR-FE)
RM2660E _55 Steering _052824 POWER ASSIST SYSTEMS _0255439 VANE PUMP(for 1GR-FE) A

POWER ASSIST SYSTEMS  VANE PUMP(for 1GR-FE)  REMOVAL  


PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the engine switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).


Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.


NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).


Hide 5.DRAIN POWER STEERING FLUID

Hide 6.DISCONNECT POWER STEERING OIL PRESSURE SWITCH CONNECTOR

C172779

a.

Disconnect the connector.


b.

Detach the wire harness clamp from the bracket.


Hide 44348A 7.DISCONNECT NO. 1 OIL RESERVOIR TO PUMP HOSE

C172780

a.

Slide the clip and disconnect the No.1 oil reservoir to pump hose from the vane pump.


Hide 44410 8.DISCONNECT PRESSURE FEED TUBE

a.
C172778

Remove the union bolt and disconnect the pressure feed tube.


b.

Remove the gasket.


Hide 44320 9.REMOVE VANE PUMP ASSEMBLY

U166650

a.

Remove the 2 bolts and vane pump.