Home › Steering › POWER ASSIST SYSTEMS › POWER STEERING ECU(for 1VD-FTV with DPF) › 2014.08–2015.08
RM2660E _55 Steering _052824 POWER ASSIST SYSTEMS _0255444 POWER STEERING ECU(for 1VD-FTV with DPF) A

POWER ASSIST SYSTEMS  POWER STEERING ECU(for 1VD-FTV with DPF)  REMOVAL  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure RHD and LHD vehicles.

·

The procedure listed below is for LHD vehicles.



PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the engine switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).


Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.


NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).


Hide 55400 3.REMOVE INSTRUMENT PANEL SAFETY PAD ASSEMBLY

Hide 89650 4.REMOVE POWER STEERING ECU ASSEMBLY

a.
C257348

Remove the bolt


b.

Disconnect the connector remove the power steering ECU.