Home › Steering › VARIABLE GEAR RATIO STEERING › VARIABLE GEAR RATIO STEERING SYSTEM › 2014.08–2015.08
RM2660E _55 Steering _052825 VARIABLE GEAR RATIO STEERING _0255448 VARIABLE GEAR RATIO STEERING SYSTEM D

VARIABLE GEAR RATIO STEERING  VARIABLE GEAR RATIO STEERING SYSTEM  DTC CHECK / CLEAR  


CHECK DTC (Using Tester)


a.

Connect the intelligent tester to the DLC3.


b.

Turn the engine switch on (IG).


c.

Turn the tester on.


d.

Enter the following menus: Chassis / VGRS / DTC.


e.

Read the DTCs.



CLEAR DTC (Using Tester)


a.

Connect the intelligent tester to the DLC3.


b.

Turn the engine switch on (IG) (do not start the engine).


c.

Turn the tester on.


d.

Enter the following menus: Chassis / VGRS / DTC.


e.

Clear the DTCs.



CHECK DTC (Using SST Check Wire)


H102392E79
0.833,1.815 1.067,1.965 0.234,0.150 10 CG 1.605,1.07 1.102,1.815 false 2.617,1.69 2.930,1.917 0.313,0.227 10 TC 1.799,1.431 2.548,1.724 false 0.108,0.065 1.437,0.302 1.329,0.237 10 Front view of DLC3:

HINT:

The master warning light comes on in diagnostic mode.


a.

Using SST check wire, connect terminals 13 (TC) and 4 (CG) of the DLC3.

SST
09843-18040  


b.

Turn the engine switch on (IG).


c.

"DIAG VGRS" is displayed on the multi-information display and the system starts searching for a malfunction.


d.
C175641

If the system is normal, "DIAG VGRS OK" is displayed.


e.
C175640

If the system has a malfunction, "DIAG VGRS xx" is displayed ("xx" is a 2-digit DTC).



CLEAR DTC (Using SST Check Wire)


H102392E79
0.833,1.815 1.067,1.965 0.234,0.150 10 CG 1.605,1.07 1.102,1.815 false 2.617,1.69 2.930,1.917 0.313,0.227 10 TC 1.799,1.431 2.548,1.724 false 0.108,0.065 1.437,0.302 1.329,0.237 10 Front view of DLC3:

a.

Turn the engine switch on (IG).


b.

Using SST check wire, connect and disconnect terminals 13 (TC) and 4 (CG) of the DLC3 4 times within 8 seconds.

SST
09843-18040  


c.

Disconnect SST check wire from the DLC3.

NOTICE:

As the stored yaw rate and G sensor value will be cleared by the above operation, it is necessary to obtain the yaw rate and G sensor zero point.



d.

Turn the engine switch off.

HINT:

If the problem still exists, DTCs may not be cleared.



e.