VARIABLE GEAR RATIO STEERING
VARIABLE GEAR RATIO STEERING SYSTEM
- PRECAUTION2014.08–2015.08from 2015.08
- PARTS LOCATION2014.08–2015.08from 2015.08
- SYSTEM DIAGRAM2014.08–2015.08from 2015.08
- SYSTEM DESCRIPTION2014.08–2015.08from 2015.08
- HOW TO PROCEED WITH TROUBLESHOOTING2014.08–2015.08from 2015.08
- INITIALIZATION2014.08–2015.08from 2015.08
- CALIBRATION2014.08–2015.08from 2015.08
- TEST MODE PROCEDURE2014.08–2015.08from 2015.08
- PROBLEM SYMPTOMS TABLE2014.08–2015.08from 2015.08
- TERMINALS OF ECU2014.08–2015.08from 2015.08
- DIAGNOSIS SYSTEM2014.08–2015.08from 2015.08
- DTC CHECK / CLEAR2014.08–2015.08from 2015.08
- FREEZE FRAME DATA2014.08–2015.08from 2015.08
- FAIL-SAFE CHART from 2015.08
- DATA LIST / ACTIVE TEST2014.08–2015.08from 2015.08
- DIAGNOSTIC TROUBLE CODE CHART2014.08–2015.08from 2015.08
- C1591/51 Actuator angle neutral calibration has not been performed.2014.08–2015.08from 2015.08
- C1592/52 The VGRS ECU (steering control ECU) detects that steering actuator angle neutral point calibration is...2014.08–2015.08from 2015.08
- C1593/53 Lock holder deviation is detected when the neutral point calibration value is calculated during actuator...2014.08–2015.08from 2015.08
- C1595/55, C15C4/682014.08–2015.08from 2015.08
- C15A1/61 Excessive current (exceeding the estimated amount) flows due to a malfunction in the motor drive circuit. 2014.08–2015.08
- C15A1/61, C15A2/62, C15A6/62 from 2015.08
- C15A2/62, C15A6/62 2014.08–2015.08
- C15A3/63, C15C5/692014.08–2015.08from 2015.08
- C15A4/64, C15A9/66, C15AA/66, C15AB/662014.08–2015.08from 2015.08
- C15A5/65 Both conditions are met for approximately 0.025 seconds or more: · The engine switch is on (IG). · A short in...2014.08–2015.08from 2015.08
- C15B1/71, C15B2/72, C15B3/73 2014.08–2015.08
- C15B1/71, C15B3/73, C15B5/82, C15B6/83 from 2015.08
- C15B2/72 When the engine switch is turned on (IG), the VGRS ECU (steering control ECU) detects a malfunction in the... from 2015.08
- C15B4/71 The memorized actuator angle value cannot be confirmed immediately after the engine switch is turned on (IG).2014.08–2015.08from 2015.08
- C15C1/74, C15C2/742014.08–2015.08from 2015.08
- C15C3/75 The steering control ECU receives a vehicle speed error signal via CAN communication. 2014.08–2015.08
- C15C3/75, C15CB/84 from 2015.08
- C15C6/77 Both conditions are met for approximately 3 seconds or more: · The engine switch is on (IG). · When the...2014.08–2015.08from 2015.08
- C15C7/78, C15C8/792014.08–2015.08from 2015.08
- U0100/56, U0122/56, U0126/56 2014.08–2015.08
- U0100/56, U0101/56, U0125/56, U0126/56, U0129/56 from 2015.08
- Steering Wheel is Off-center or Deviates from Neutral Position2014.08–2015.08from 2015.08
- VGRS System Stops or does not Operate2014.08–2015.08from 2015.08
- Steering Angle Differs between Left and Right2014.08–2015.08from 2015.08
- Steering Wheel Vibrates or Abnormal Noise is Heard from Steering Wheel 2014.08–2015.08
- VGRS System Suspends right after Engine Start from 2015.08
- Master Warning Light Malfunction 2014.08–2015.08
STEERING ACTUATOR
STEERING CONTROL ECU (for LHD)
STEERING CONTROL ECU (for RHD)