Home › Steering › VARIABLE GEAR RATIO STEERING › VARIABLE GEAR RATIO STEERING SYSTEM › 2014.08–2015.08
RM2660E _55 Steering _052825 VARIABLE GEAR RATIO STEERING _0255448 VARIABLE GEAR RATIO STEERING SYSTEM C

VARIABLE GEAR RATIO STEERING  VARIABLE GEAR RATIO STEERING SYSTEM  U0100/56  Lost Communication with ECM / PCM "A"  U0122/56  Lost Communication with Vehicle Dynamics Control Module  U0126/56  Lost Communication with Steering Angle Sensor Module  


DESCRIPTION

The steering control ECU receives signals from the skid control ECU, ECM and steering angle sensor via CAN communication. When DTCs indicating a CAN communication system malfunction are output, repair the CAN communication system first.

DTC Code DTC Detection Condition Trouble Area
U0100/56 The steering control ECU detects an error in reception (from ECM) via CAN communication.
·

CAN communication system

·

ECM


U0122/56 The steering control ECU detects an error in reception (from skid control ECU) via CAN communication.
·

CAN communication system

·

Skid control ECU


U0126/56 The steering control ECU detects an error in reception (from steering angle sensor) via CAN communication.
·

CAN communication system

·

Steering angle sensor



PROCEDURE

1.CHECK DTC
a.

Using the intelligent tester, check if the CAN communication system is functioning normally (See page Power Source / Network>NETWORKING>CAN COMMUNICATION SYSTEM(for LHD)>DIAGNOSIS SYSTEM for LHD, Power Source / Network>NETWORKING>CAN COMMUNICATION SYSTEM(for RHD)>DIAGNOSIS SYSTEM for RHD).

Result
Result Proceed to
DTC is not output A
DTC is output (for LHD) B
DTC is output (for RHD) C



A

B

GO TO CAN COMMUNICATION SYSTEM (HOW TO PROCEED WITH TROUBLESHOOTING)

C

GO TO CAN COMMUNICATION SYSTEM (HOW TO PROCEED WITH TROUBLESHOOTING)