Home › Steering › VARIABLE GEAR RATIO STEERING › VARIABLE GEAR RATIO STEERING SYSTEM › from 2015.08
RM2660E _55 Steering _052825 VARIABLE GEAR RATIO STEERING _0255448 VARIABLE GEAR RATIO STEERING SYSTEM C

VARIABLE GEAR RATIO STEERING  VARIABLE GEAR RATIO STEERING SYSTEM  U0100/56  Lost Communication with ECM / PCM "A"  U0101/56  Lost Communication with TCM  U0125/56  Lost Communication with Yaw Rate Sensor Module  U0126/56  Lost Communication with Steering Angle Sensor Module  U0129/56  Lost Communication with Brake System Control Module  


DESCRIPTION

The VGRS ECU (steering control ECU) receives signals from the ECM, TCM, skid control ECU (master cylinder solenoid), yaw rate sensor (airbag sensor assembly) and steering sensor via CAN communication. When DTCs indicating a CAN communication system malfunction are output, repair the CAN communication system first.

DTC No. DTC Detection Condition Trouble Area
U0100/56 Both conditions are met for approximately 3 seconds or more:
·

The engine switch is on (IG).

·

The signal from the ECM is lost.


·

ECM

·

CAN communication system


U0101/56 Both conditions are met for approximately 12 seconds or more:
·

The engine switch is on (IG).

·

The signal from the TCM*1 (ECM*2) is lost.


·

TCM*1

·

ECM*2

·

CAN communication system


U0125/56 Both conditions are met for approximately 12 seconds or more:
·

The engine switch is on (IG).

·

The signal from the yaw rate sensor (airbag sensor assembly) is lost.


·

Yaw rate sensor (Airbag sensor assembly)

·

CAN communication system


U0126/56 Both conditions are met for approximately 3 seconds or more:
·

The engine switch is on (IG).

·

The signal from the steering sensor is lost.


·

Steering sensor

·

CAN communication system


U0129/56 Both conditions are met for approximately 3 seconds or more:
·

The engine switch is on (IG).

·

The signal from the skid control ECU (master cylinder solenoid) is lost.


·

Skid control ECU (master cylinder solenoid)

·

CAN communication system



*1: for 3UR-FE

*2: for 1UR-FE and 1VD-FTV


PROCEDURE

1.CHECK DTC

b.

Check for DTCs (See page Steering>VARIABLE GEAR RATIO STEERING>VARIABLE GEAR RATIO STEERING SYSTEM>DTC CHECK / CLEAR).

Result
Result Proceed to
DTC is not output A
DTC is output (for LHD with Central Gateway ECU) B
DTC is output (for LHD without Central Gateway ECU) C
DTC is output (for RHD with Central Gateway ECU) D
DTC is output (for RHD without Central Gateway ECU) E



A

B

C

D

E