Home › Steering › VARIABLE GEAR RATIO STEERING › VARIABLE GEAR RATIO STEERING SYSTEM › from 2015.08
RM2660E _55 Steering _052825 VARIABLE GEAR RATIO STEERING _0255448 VARIABLE GEAR RATIO STEERING SYSTEM C

VARIABLE GEAR RATIO STEERING  VARIABLE GEAR RATIO STEERING SYSTEM  C15C3/75  Brake System Control Module  C15CB/84  VSC System Malfunction  


DESCRIPTION

The VGRS ECU (steering control ECU) detects a vehicle speed error by receiving an error signal from the skid control ECU (master cylinder solenoid) via CAN communication.

If the VGRS ECU (steering control ECU) detects this error signal, it turns the master warning light on, and stores this DTC.

DTC No. DTC Detection Condition Trouble Area
C15C3/75 All conditions are met:
·

3 seconds or more after the engine switch is turned on (IG).

·

Power source voltage at 10 to 16 V.

·

Information regarding a vehicle speed signal malfunction is received for approximately 3 seconds or more from the skid control ECU (master cylinder solenoid) via CAN communication or there is a VDIM monitoring malfunction


Skid control ECU (Master cylinder solenoid)
C15CB/84 All conditions are met:
·

3 seconds or more after the engine switch is turned on (IG).

·

Power source voltage at 10 to 16 V.

·

Information regarding a skid control ECU (master cylinder solenoid) internal malfunction is received 3 seconds or more via CAN communication.


Skid control ECU (Master cylinder solenoid)

CAUTION / NOTICE / HINT

NOTICE:

When replacing the master cylinder solenoid, perform zero point calibration and store system information (See page Brake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>VEHICLE STABILITY CONTROL SYSTEM>CALIBRATION).


PROCEDURE

1.CHECK DTC (VEHICLE STABILITY CONTROL SYSTEM)
a.

Check for DTCs in the Vehicle Stability Control System (See page Brake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>VEHICLE STABILITY CONTROL SYSTEM>DTC CHECK / CLEAR).



NEXT

GO TO VEHICLE STABILITY CONTROL SYSTEM (DIAGNOSTIC TROUBLE CODE CHART)