When the engine switch is turned on (IG), the IG power source circuit supplies positive (+) voltage to the multiplex tilt and telescopic ECU.
Inspect the fuses for circuits related to this system before performing the following inspection procedure.
Disconnect the multiplex tilt and telescopic ECU connector.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
|---|---|---|
| E144-10 (IG) - Body ground | Engine switch on (IG) | 11 to 14 V |
| *a | Front view of wire harness connector
(to Multiplex Tilt and Telescopic ECU) |
OK
NG
OK
NG