The signals generated by operating the manual switch are sent to the multiplex tilt and telescopic ECU through the serial line.
Use the Data List to check if the tilt and telescopic manual switch is functioning properly.
| Tester Display | Measurement Item/Range | Normal Condition | Normal Condition |
|---|---|---|---|
| Tilt Up switch | Input state of tilt up by manual switch/ON or OFF | ON: Tilt up activated by manual switch
OFF: Tilt up not activated by manual switch |
- |
| Tilt Down Switch | Input state of tilt down by manual switch/ON or OFF | ON: Tilt down activated by manual switch
OFF: Tilt down not activated by manual switch |
- |
| Telesco Short Switch | Input state of telescopic short by manual switch/ON or OFF | ON: Telescopic short activated by manual switch
OFF: Telescopic short not activated by manual switch |
- |
| Telesco Long Switch | Input state of telescopic long by manual switch/ON or OFF | ON: Telescopic long activated by manual switch
OFF: Telescopic long not activated by manual switch |
- |
| Result | Proceed to |
|---|---|
| "ON" is displayed on the intelligent tester screen when each switch is turned on.
"OFF" is displayed on the intelligent tester screen when each switch is turned off. |
A |
| "ON" is not displayed on the intelligent tester screen when each switch is turned on.
"OFF" is not displayed on the intelligent tester screen when each switch is turned off. |
B |
A
B