Home › Steering › STEERING COLUMN › POWER TILT AND POWER TELESCOPIC STEERING COLUMN SYSTEM › 2014.08–2015.08
RM2660E _55 Steering _052826 STEERING COLUMN _0255453 POWER TILT AND POWER TELESCOPIC STEERING COLUMN SYSTEM C

STEERING COLUMN  POWER TILT AND POWER TELESCOPIC STEERING COLUMN SYSTEM  B2624  Vehicles Speed Malfunction  


DESCRIPTION

The multiplex tilt and telescopic ECU forms a network with the ECUs of other systems through the communication bus. Each ECU informs the other ECUs that it is connected to the network by outputting a specified signal (periodic signal) to the communication bus on a regular schedule. The multiplex tilt and telescopic ECU receives vehicle speed signals from the combination meter via the communication bus to prevent improper operation of the auto away/return function during driving.

DTC Code Detection Condition Trouble Area
B2624
·

The auto away function is disabled with the last vehicle speed signal* at 10 km/h (6 mph) or more.

·

Vehicle speed signal is lost for 5 seconds or more and the auto away/return function is disabled.


·

CAN communication system

·

Meter/gauge system

·

Multiplex tilt and telescopic ECU



HINT:

*: If the engine switch is turned off immediately after the vehicle comes to a sudden stop, the last vehicle speed signal may not be 0 km/h (0 mph).


PROCEDURE

1.CHECK OTHER DTC OUTPUT
a.

Check if DTC B2621 is output (See page Steering>STEERING COLUMN>POWER TILT AND POWER TELESCOPIC STEERING COLUMN SYSTEM>DTC CHECK / CLEAR).

Result
Result Proceed to
B2621 is not output A
B2621 is output B



A

2.READ VALUE USING INTELLIGENT TESTER (SPEED SIGNAL)

B

2.READ VALUE USING INTELLIGENT TESTER (SPEED SIGNAL)
a.

Use the Data List to check if the speed signal is functioning properly.

Tilt & Telescopic
Tester Display Measurement Item/Range Normal Condition Diagnostic Note
Freeze Speed Info Vehicle speed data/min.: 0 km/h (0 mph), max.: 255 km/h (158 mph) Actual vehicle speed -


Result
Result Proceed to
Tester indication is normal A
Tester indication is abnormal B

HINT:

A vehicle speed of 3 km/h (2 mph) or more may be displayed on the intelligent tester screen immediately after the vehicle comes to a sudden stop. This is caused by a delay in vehicle signal input via the communication bus and is not a malfunction.



A

REPLACE MULTIPLEX TILT AND TELESCOPIC ECU

B

GO TO METER/GAUGE SYSTEM (HOW TO PROCEED WITH TROUBLESHOOTING)