Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing the steering column (See page Vehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>PRECAUTION).
1. FRONT WHEELS FACING STRAIGHT AHEAD
2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
After the engine switch is turned off, the navigation system requires approximately 90 seconds to record various types of memory and settings. As a result, after turning the engine switch off, wait 90 seconds or more before disconnecting the cable from the negative (-) battery terminal.
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).
45130
3.REMOVE STEERING PAD
45100
4.REMOVE STEERING WHEEL ASSEMBLY
Remove the steering wheel set nut.
for A Type:
Put matchmarks on the steering wheel and main shaft.
| *a | Matchmark |
Using SST, remove the steering wheel assembly.
| *a | Hold |
| *b | Turn |
Apply a small amount of grease to the threads and tip of SST (09953-05020) before use.
for B Type:
Put matchmarks on the steering wheel and main shaft.
| *a | Matchmark |
Using SST, remove the steering wheel assembly.
| *a | Hold |
| *b | Turn |
Apply a small amount of grease to the threads and tip of SST (09953-05020) before use.
84250A
5.REMOVE STEERING PAD SWITCH ASSEMBLY (w/ Steering Pad Switch)
Remove the 4 screws.
|
Remove in this Direction (1) |
|
Remove in this Direction (2) |
While pushing the steering pad switch assembly in the direction shown by the arrow (1) in the illustration to disengage the claw, pull the steering pad switch assembly in the direction shown by the arrow (2) in the illustration to disengage the guide pin.
|
Remove in this Direction (1) |
|
Remove in this Direction (2) |
While pushing the steering pad switch assembly in the direction shown by the arrow (1) in the illustration to disengage the claw, pull the steering pad switch assembly in the direction shown by the arrow (2) in the illustration to disengage the guide pin.
Remove the part from the steering wheel sub-assembly.
Use the same procedure for both sides.
84247A
6.REMOVE STEERING PAD SWITCH LH (w/ Steering Pad Switch)
Refer to "REMOVE STEERING PAD SWITCH ASSEMBLY".
84632
7.REMOVE CRUISE CONTROL MAIN SWITCH (w/ Cruise Control System)
84259
8.REMOVE STEERING PAD COVER LH (for Type A)
Remove the screw and 3 guide pins, remove the steering pad cover LH.
84258
9.REMOVE STEERING PAD COVER RH (for Type A)
Refer to "REMOVE STEERING PAD COVER LH".
45116
10.REMOVE NO. 1 STEERING WHEEL ORNAMENT (for Type B)
Remove the 4 screws.
Detach the 2 claws and 2 guide pins, remove the No. 1 steering wheel ornament.
45117
11.REMOVE NO. 2 STEERING WHEEL ORNAMENT (for Type B)
Refer to "REMOVE NO. 1 STEERING WHEEL ORNAMENT".
45713A
12.REMOVE STEERING SHAKE DAMPER (Steering Shake Damper)
Remove the 2 screws and remove the steering shake damper.
45184
13.REMOVE STEERING WHEEL BOSS LOWER COVER (w/o Steering Heater)
for Type A
Remove the 2 screws and 4 claws, and remove the steering wheel boss lower cover.
for Type B
Detach the 6 claws remove the steering wheel boss lower cover.