Use the same procedures for the LH side and RH side.
The procedures listed below are for the LH side.
1. PRECAUTION
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).
2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).
55510F
3.REMOVE NO. 1 SPEAKER OPENING COVER ASSEMBLY
86160L
4.REMOVE FRONT NO. 4 SPEAKER ASSEMBLY
Remove the 2 bolts.
Remove the speaker and then disconnect the speaker connector.
Do not touch the cone part of the speaker.
74610A
5.REMOVE ASSIST GRIP SUB-ASSEMBLY
62212
6.REMOVE FRONT PILLAR GARNISH LH
55408F
7.REMOVE NO. 1 INSTRUMENT PANEL SPEAKER PANEL SUB-ASSEMBLY
86160P
8.REMOVE FRONT NO. 2 SPEAKER ASSEMBLY
Remove the 2 bolts.
Remove the speaker and then disconnect the speaker connector.
Do not touch the cone part of the speaker.