Perform the auto-search of the radio and check that it functions normally.
Radio auto-search functions normally.
OK
(See pageAudio / Visual / Telematics>AUDIO / VIDEO>RADIO RECEIVER (w/o Stereo Component Amplifier)>REMOVAL)
NG
Check if the telephone antenna or other optional components are installed.
Optional component(s) installed.
OK
NG
With the ignition switch ACC, turn on the radio and choose the AM mode.
Place the tip of a screwdriver on the antenna and check that noise is heard from the speakers.
Noise is heard.
OK
(See pageAudio / Visual / Telematics>AUDIO / VIDEO>RADIO RECEIVER (w/o Stereo Component Amplifier)>REMOVAL)
NG
Remove the antenna plug of the radio receiver.
With the radio receiver connector connected, turn the ignition switch to ACC.
Turn on the radio and choose the AM mode.
Place a flat-head screwdriver or a piece of metal, such as a thin wire, on the antenna jack of the radio receiver. Check that noise is heard from the speakers.
Noise is heard.
OK
NG
(See pageAudio / Visual / Telematics>AUDIO / VIDEO>RADIO RECEIVER (w/o Stereo Component Amplifier)>REMOVAL)