Home › Audio / Visual / Telematics › AUDIO / VIDEO › RADIO RECEIVER (w/o Stereo Component Amplifier) › 2014.08–2015.08
RM2660E _56 Audio / Visual / Telematics _052828 AUDIO / VIDEO _0255473 RADIO RECEIVER(w/o Stereo Component Amplifier) A

AUDIO / VIDEO  RADIO RECEIVER(w/o Stereo Component Amplifier)  REMOVAL  


PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).


Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).


Hide 55510F 3.REMOVE NO. 1 SPEAKER OPENING COVER ASSEMBLY

Hide 55670 4.REMOVE NO. 3 INSTRUMENT PANEL REGISTER ASSEMBLY

Hide 55680A 5.REMOVE NO. 4 INSTRUMENT PANEL REGISTER ASSEMBLY

Hide 55412C 6.REMOVE NO. 1 INSTRUMENT CLUSTER FINISH PANEL CENTER

a.
B181491

Detach the 10 claws on the backside of the cluster finish panel to remove it.


Hide 86120 7.REMOVE RADIO RECEIVER ASSEMBLY WITH BRACKET

a.
B181490

Remove the 2 screws and 2 bolts.


b.

Disconnect the connectors and remove the radio receiver.


Hide 86211 8.REMOVE NO. 1 RADIO BRACKET

a.
B181492

Remove the 3 bolts and bracket.


Hide 86212 9.REMOVE NO. 2 RADIO BRACKET

a.
B181493

Remove the 3 bolts and bracket.


Hide 84330 11.REMOVE HAZARD WARNING SIGNAL SWITCH ASSEMBLY