Home › Audio / Visual / Telematics › AUDIO / VIDEO › AUDIO AND VISUAL SYSTEM(w/ Navigation System) › 2014.08–2015.08
RM2660E _56 Audio / Visual / Telematics _052828 AUDIO / VIDEO _0255478 AUDIO AND VISUAL SYSTEM(w/ Navigation System) J

AUDIO / VIDEO  AUDIO AND VISUAL SYSTEM(w/ Navigation System)  Visual Mute Signal Circuit between Radio Receiver and Multi-display  


DESCRIPTION

The multi-media module receiver assembly sends a visual mute signal to the multi-display assembly. As a result, a black screen is inserted when the screen changes so that noise and distorted images are not displayed.

When an open exists in the circuit, noise and distorted images will be displayed instead of a black screen.

When a short exists in the circuit, even though the multi-display assembly is operating normally, noise and distorted images will be displayed (black screen will not be displayed) during screen changes or the black screen will always be displayed.

WIRING DIAGRAM

E245681E82
0.958,1.563 1.417,1.76 0.458,0.198 10 false F79 0.948,1.75 2.604,2.01 1.656,0.26 10 false Multi-display Assembly 1.542,0.917 2,1.115 0.458,0.198 10 false VMT1 2.01,0.781 2.24,0.979 0.229,0.198 10 false 11 5.021,0.802 5.229,0.99 0.208,0.188 10 false 10 5.26,0.917 5.719,1.115 0.458,0.198 10 false VMTF 5.156,1.51 5.615,1.708 0.458,0.198 10 false F77 5.167,1.708 6.448,2.125 1.281,0.417 10 false Multi-media Module Receiver Assembly

PROCEDURE

1.CHECK MULTI-MEDIA MODULE RECEIVER ASSEMBLY
a.
U166269E01
0.174,0.109 0.659,0.269 0.485,0.161 10 *a 2.402,1.777 2.887,1.937 0.485,0.161 10 VMTF 1.653,0.266 1.966,0.427 0.313,0.161 10 F77 1.887,1.111 2.305,1.858 2.305,1.858 2.371,1.858 false

Measure the voltage according to the value(s) in the table below.

Standard Voltage:
Tester Connection Condition Specified Condition
F77-10 (VMTF) - Body ground Engine switch on (ACC), screen display changes. 3.5 V or higher → Below 1 V → 3.5 V or higher


Text in Illustration
*a Component with harness connected
(Multi-media Module Receiver Assembly)



OK

2.CHECK HARNESS AND CONNECTOR (MULTI-MEDIA MODULE RECEIVER ASSEMBLY - MULTI-DISPLAY ASSEMBLY)

NG

REPLACE MULTI-MEDIA MODULE RECEIVER ASSEMBLY

2.CHECK HARNESS AND CONNECTOR (MULTI-MEDIA MODULE RECEIVER ASSEMBLY - MULTI-DISPLAY ASSEMBLY)
a.

Disconnect the F77 multi-media module receiver assembly connector.


b.

Disconnect the F79 multi-display assembly connector.


c.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
F77-10 (VMTF) - F79-11 (VMT1) Always Below 1 Ω
F77-10 (VMTF) - Body ground Always 10 kΩ or higher




OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR