| DTC No. | DTC Detection Condition | Trouble Area |
|---|---|---|
| CB-45 | Communication error with USB device | ·
Multi-media interface ECU ·
USB device |
| CB-46 | "iPod" control software malfunction | ·
Multi-media interface ECU ·
"iPod" |
| CB-47 | Communication error with "iPod" |
After the inspection is completed, clear the DTCs.
Disconnect the USB device or "iPod" from the No. 1 stereo jack adapter assembly.
Turn the engine switch off.
When one of these DTCs has been stored, it is necessary to turn off the engine switch to make it possible for the vehicle to recognize a new device when it is connected.
Turn the engine switch on (ACC).
Connect a known good USB device or "iPod" to the No. 1 stereo jack adapter assembly.
If the malfunction occurred when a USB device was in use, use another USB device for the inspection. If the malfunction occurred when an "iPod" was in use, use another "iPod" for the inspection.
NEXT
Clear the DTCs (See page Audio / Visual / Telematics>AUDIO / VIDEO>AUDIO AND VISUAL SYSTEM(w/o Navigation System)>DTC CHECK / CLEAR).
NEXT
Recheck for DTCs and check if the same DTC occurs again.
If DTCs are detected frequently, replace the multi-media interface ECU.
Malfunction disappears.
OK
NG