1. PRECAUTION
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).
2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).
3.REMOVE FRONT SEAT ASSEMBLY RH (for Manual Seat)
Remove the front seat assembly RH (See page Vehicle Interior>SEAT>FRONT SEAT ASSEMBLY (for Manual Seat)>REMOVAL).
4.REMOVE FRONT SEAT ASSEMBLY RH (for Power Seat)
Remove the front seat assembly RH (See page Vehicle Interior>SEAT>FRONT SEAT ASSEMBLY (for Power Seat)>REMOVAL).
55317A
5.REMOVE INSTRUMENT SIDE PANEL RH (w/o Airbag Cut Off Switch)
6.REMOVE INSTRUMENT SIDE PANEL RH (w/ Airbag Cut Off Switch)
67913B
7.REMOVE FRONT DOOR SCUFF PLATE RH
62111C
8.REMOVE COWL SIDE TRIM BOARD RH
58510D
9.REMOVE FRONT FLOOR CARPET ASSEMBLY
Pull back the carpet far enough so that the selector can be removed. For further details, refer to the removal procedure (See page Audio / Visual / Telematics>AUDIO / VIDEO>STEREO COMPONENT AMPLIFIER>REMOVAL).
861A1
10.REMOVE MULTI-MEDIA INTERFACE ECU
Disconnect the connectors.
Remove the 2 bolts and multi-media interface ECU.
861A2
11.REMOVE NO. 1 MULTI-MEDIA INTERFACE BRACKET
Remove the 2 bolts and bracket.
861A3
12.REMOVE NO. 2 MULTI-MEDIA INTERFACE BRACKET
Remove the 2 bolts and bracket.