1. PRECAUTION
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).
2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).
55449C
3.REMOVE NO. 2 INSTRUMENT PANEL FINISH PANEL CUSHION
55403C
4.REMOVE LOWER INSTRUMENT PANEL PAD SUB-ASSEMBLY LH
55448A
5.REMOVE NO. 1 INSTRUMENT PANEL FINISH PANEL CUSHION
55402C
6.REMOVE LOWER INSTRUMENT PANEL PAD SUB-ASSEMBLY RH
33504F
7.REMOVE SHIFT LEVER KNOB SUB-ASSEMBLY
55406B
8.REMOVE LOWER CENTER INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY
58805C
9.REMOVE REAR UPPER CONSOLE PANEL SUB-ASSEMBLY
58803C
10.REMOVE CONSOLE CUP HOLDER BOX SUB-ASSEMBLY
58804A
11.REMOVE UPPER CONSOLE PANEL SUB-ASSEMBLY
86190C
12.REMOVE NO. 1 STEREO JACK ADAPTER ASSEMBLY
Detach the 2 claws and remove the stereo jack adapter.
58903A
13.REMOVE REAR CONSOLE END PANEL SUB-ASSEMBLY
86192B
14.REMOVE HEADPHONE TERMINAL
Remove the 2 screws.
Detach the connector clamp.
Detach the 4 claws and remove the terminal.