Home › Audio / Visual / Telematics › AUDIO / VIDEO › AUDIO AND VISUAL SYSTEM(for Radio Receiver Type) › from 2015.08
RM2660E _56 Audio / Visual / Telematics _052828 AUDIO / VIDEO _0255486 AUDIO AND VISUAL SYSTEM(for Radio Receiver Type) J

AUDIO / VIDEO  AUDIO AND VISUAL SYSTEM(for Radio Receiver Type)  Microphone Circuit between Microphone and Radio Receiver  


DESCRIPTION

Using this circuit, the radio receiver assembly sends power to the telephone microphone assembly, and the telephone microphone assembly sends microphone signals to the radio receiver assembly.

WIRING DIAGRAM

E335087E01
0.515,2.661 2.331,2.858 1.817,0.197 10 Map Light Assembly 0.774,0.562 1.549,1.244 0.775,0.683 10 Telephone Microphone Assembly 1.859,0.821 2.224,0.980 0.365,0.159 10 MI1+ 1.882,1.211 2.225,1.370 0.342,0.159 10 MIC- 1.85,0.397 2.294,0.556 0.444,0.159 10 ACC 4.43,1.84 5.043,1.999 0.613,0.159 10 Shielded 2.833,1.826 3.446,1.985 0.613,0.159 10 Shielded 2.304,2.012 2.553,2.172 0.249,0.159 10 20 2.304,0.829 2.516,0.988 0.211,0.159 10 27 2.304,1.218 2.516,1.377 0.211,0.159 10 26 2.304,0.412 2.553,0.571 0.249,0.159 10 25 5.462,2.012 5.590,2.172 0.128,0.159 10 6 5.389,1.611 5.590,1.771 0.201,0.159 10 18 5.462,0.829 5.572,0.988 0.110,0.159 10 5 5.389,1.218 5.572,1.377 0.183,0.159 10 19 5.462,0.412 5.590,0.571 0.128,0.159 10 4 5.583,2.635 6.700,2.993 1.117,0.358 10 Radio Receiver Assembly 0.515,2.448 0.999,2.658 0.484,0.211 10 R7 5.583,2.448 6.006,2.623 0.423,0.175 10 F114 5.704,0.924 6.144,1.083 0.441,0.159 10 MIN+ 5.704,1.302 6.144,1.461 0.441,0.159 10 MIN- 5.704,1.699 6.188,1.858 0.485,0.159 10 SGND 5.704,0.499 6.144,0.659 0.441,0.159 10 MACC 1.823,2.006 2.224,2.165 0.401,0.159 10 SNS2 5.704,2.096 6.144,2.255 0.441,0.159 10 SNS2

PROCEDURE

1.CHECK HARNESS AND CONNECTOR (RADIO RECEIVER ASSEMBLY - MAP LIGHT ASSEMBLY)
a.

Disconnect the F114 radio receiver assembly connector.


b.

Disconnect the R7 map light assembly connector.


c.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
F114-6 (SNS2) - R7-20 (SNS2) Always Below 1 Ω
F114-4 (MACC) - R7-25 (ACC) Always Below 1 Ω
F114-5 (MIN+) - R7-27 (MI1+) Always Below 1 Ω
F114-19 (MIN-) - R7-26 (MIC-) Always Below 1 Ω
F114-4 (MACC) - Body ground Always 10 kΩ or higher
F114-5 (MIN+) - Body ground Always 10 kΩ or higher
F114-19 (MIN-) - Body ground Always 10 kΩ or higher
F114-18 (SGND) - Body ground Always 10 kΩ or higher




OK

2.CHECK RADIO RECEIVER ASSEMBLY

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR

2.CHECK RADIO RECEIVER ASSEMBLY
a.
U166447E02
2.031,1.323 2.146,1.917 2.146,1.917 2.375,1.917 false 2.167,1.333 2.396,1.698 2.396,1.698 2.625,1.698 false 2.156,1.073 2.479,0.385 2.479,0.385 2.708,0.385 false 2.427,1.833 2.792,2.01 0.365,0.177 10 false MIN- 2.656,1.615 3.104,1.792 0.448,0.177 10 false SGND 2.75,0.292 3.198,0.469 0.448,0.177 10 false MACC 0.094,0.073 0.333,0.25 0.24,0.177 10 false *a 0.188,1.01 0.573,1.188 0.385,0.177 10 false F114

Remove the radio receiver assembly with its connectors still connected (See page Audio / Visual / Telematics>AUDIO / VIDEO>RADIO RECEIVER (w/o Stereo Component Amplifier)>REMOVAL).


b.

Measure the voltage according to the value(s) in the table below.

Standard Voltage:
Tester Connection Switch Condition Specified Condition
F114-4 (MACC) - Body ground Ignition switch ACC 4 to 6 V



c.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
F114-18 (SGND) - Body ground Always Below 1 Ω
F114-19 (MIN-) - Body ground Always Below 1 Ω



Text in Illustration
*a Component with harness connected
(Radio Receiver Assembly)


OK

3.CHECK TELEPHONE MICROPHONE ASSEMBLY

NG

3.CHECK TELEPHONE MICROPHONE ASSEMBLY
a.

Replace the telephone microphone assembly with a known good one (See page Audio / Visual / Telematics>AUDIO / VIDEO>MICROPHONE AMPLIFIER>REMOVAL).


b.

Check that the malfunction disappears.

OK:

Malfunction disappears.




OK

END (TELEPHONE MICROPHONE ASSEMBLY IS DEFECTIVE)

NG