1. PRECAUTION
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).
2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).
55510F
3.REMOVE NO. 1 SPEAKER OPENING COVER ASSEMBLY
55670
4.REMOVE NO. 3 INSTRUMENT PANEL REGISTER ASSEMBLY
55680A
5.REMOVE NO. 4 INSTRUMENT PANEL REGISTER ASSEMBLY
55412C
6.REMOVE NO. 1 CENTER INSTRUMENT CLUSTER FINISH PANEL
86120
7.REMOVE RADIO RECEIVER ASSEMBLY WITH BRACKET
w/o Entry and Start System:
Remove the 2 screws and 2 bolts.
Disconnect the connectors and remove the radio receiver.
w/ Entry and Start System:
Remove the 2 screws and 2 bolts.
Disconnect the connectors and remove the radio receiver.
86211
8.REMOVE NO. 1 RADIO BRACKET
w/o Entry and Start System:
Remove the 3 screws and bracket.
w/ Entry and Start System:
Remove the 3 screws and bracket.
86212
9.REMOVE NO. 2 RADIO BRACKET
w/o Entry and Start System:
Remove the 3 screws and bracket.
w/ Entry and Start System:
Remove the 3 screws and bracket.