Home › Audio / Visual / Telematics › AUDIO / VIDEO › AUDIO AND VISUAL SYSTEM (w/ Multi-display) › from 2015.08
RM2660E _56 Audio / Visual / Telematics _052828 AUDIO / VIDEO _0255488 AUDIO AND VISUAL SYSTEM(w/ Multi-display) J

AUDIO / VIDEO  AUDIO AND VISUAL SYSTEM(w/ Multi-display)  AVC-LAN Circuit  


DESCRIPTION

Each audio system component connected to the AVC-LAN (communication bus) transfers switch signals using the audio visual communication local area network.

If a short to +B or short to ground occurs in the AVC-LAN, the audio system will not function normally because communication is not possible.

WIRING DIAGRAM

E330590E05
1.068,1.132 1.391,1.309 0.323,0.177 10 TX- 1.068,0.628 1.391,0.804 0.323,0.177 10 TX+ 1.439,0.516 1.658,0.692 0.218,0.177 10 11 1.439,0.985 1.658,1.162 0.218,0.177 10 10 0.368,1.468 0.655,1.631 0.288,0.163 10 F75 0.361,1.608 1.669,1.778 1.309,0.170 10 Parking Assist ECU 3.044,0.635 3.442,0.804 0.399,0.170 10 TX1+ 3.044,1.097 3.442,1.267 0.399,0.170 10 TX1- 3.555,0.635 3.954,0.804 0.399,0.170 10 TX3+ 3.555,1.097 3.954,1.267 0.399,0.170 10 TX3- 5.579,0.635 5.978,0.804 0.399,0.170 10 TX+ 5.579,1.097 5.978,1.267 0.399,0.170 10 TX- 2.889,0.523 3.045,0.685 0.156,0.163 10 7 5.404,0.523 5.560,0.685 0.156,0.163 10 7 2.889,1.006 3.045,1.169 0.156,0.163 10 8 3.996,0.523 4.194,0.699 0.198,0.177 10 45 3.996,1.013 4.194,1.190 0.198,0.177 10 46 5.362,1.013 5.560,1.190 0.198,0.177 10 19 2.854,1.531 3.184,1.701 0.330,0.170 10 F77 2.847,1.685 4.191,2.057 1.343,0.371 10 Multi-media Module Receiver Assembly 5.376,1.706 5.706,1.876 0.330,0.170 10 F79 5.369,1.861 6.965,2.051 1.596,0.191 10 Multi-display Assembly 0.767,2.295 2.826,2.472 2.059,0.177 10 : AVC-LAN Communication Line

PROCEDURE

1.INSPECT MULTI-MEDIA MODULE RECEIVER ASSEMBLY
a.
E238990E22
2.365,1.01 2.833,0.573 false 2.24,1 1.917,0.635 false 2.26,1.375 1.99,1.781 false 2.385,1.375 2.656,1.74 false 2.885,0.479 3.281,0.656 0.396,0.177 10 false TX1+ 1.813,1.813 2.208,1.99 0.396,0.177 10 false TX3- 2.5,1.771 2.896,1.948 0.396,0.177 10 false TX3+ 1.583,0.521 1.979,0.698 0.396,0.177 10 false TX1-

Remove the multi-media module receiver assembly (See page Audio / Visual / Telematics>AUDIO / VIDEO>RADIO RECEIVER (w/ Multi-display)>REMOVAL).


b.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
7 (TX1+) - 8 (TX1-) Always 60 to 80 Ω
45 (TX3+) - 46 (TX3-) Always 60 to 80 Ω




OK

2.CHECK HARNESS AND CONNECTOR (AVC-LAN CIRCUIT)

NG

REPLACE MULTI-MEDIA MODULE RECEIVER ASSEMBLY

2.CHECK HARNESS AND CONNECTOR (AVC-LAN CIRCUIT)
a.

Disconnect the F77 multi-media module receiver assembly connector.


b.

Disconnect the F79 multi-display assembly connector.


c.

Disconnect the F75 parking assist ECU connector.


d.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
F77-45 (TX3+) - F79-7 (TX+) Always Below 1 Ω
F77-46 (TX3-) - F79-19 (TX-) Always Below 1 Ω
F77-7 (TX1+) - F75-11 (TX+) Always Below 1 Ω
F77-8 (TX1-) - F75-10 (TX- ) Always Below 1 Ω
F77-45 (TX3+) - Body ground Always 10 kΩ or higher
F77-46 (TX3-) - Body ground Always 10 kΩ or higher
F77-7 (TX1+) - Body ground Always 10 kΩ or higher
F77-8 (TX1-) - Body ground Always 10 kΩ or higher




OK

3.INSPECT MALFUNCTIONING PARTS

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR

3.INSPECT MALFUNCTIONING PARTS
a.

Disconnect and reconnect each slave unit one by one until the master unit returns to normal operation.

HINT:
·

Check all slave units.

·

When disconnecting a slave unit causes the master unit to return to normal operation, this indicates that the slave unit is malfunctioning. Replace the malfunctioning slave unit.



OK:

Master unit returns to normal operation.




OK

REPLACE MALFUNCTIONING PARTS

NG

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE