Home › Audio / Visual / Telematics › AUDIO / VIDEO › AUDIO AND VISUAL SYSTEM (w/ Multi-display) › from 2015.08
RM2660E _56 Audio / Visual / Telematics _052828 AUDIO / VIDEO _0255488 AUDIO AND VISUAL SYSTEM(w/ Multi-display) C

AUDIO / VIDEO  AUDIO AND VISUAL SYSTEM(w/ Multi-display)  B15F7  Certification ECU Vehicle Information Reading/Writing Process Malfunction  


DESCRIPTION

This DTC is stored when items controlled by the certification ECU (smart key ECU assembly) cannot be customized via the audio and visual system vehicle customization screen.

HINT:

The certification ECU (smart key ECU assembly) controls the entry and start system (for Entry Function) related items that are customizable via the multi-display assembly screen.


DTC Code DTC Detection Condition Trouble Area
B15F7 Certification ECU (smart key ECU assembly) vehicle setting processing error.
·

CAN communication system

·

Entry and start system (for Entry Function)

·

Certification ECU (smart key ECU assembly)

·

Multi-media module receiver assembly



PROCEDURE

1.CHECK CAN COMMUNICATION SYSTEM
a.

Use the GTS to check if the CAN communication system is functioning normally.


OK:

CAN communication system DTCs are not output.


Result
Result Proceed to
OK A
NG (for LHD with Central Gateway ECU) B
NG (for LHD without Central Gateway ECU) C
NG (for RHD with Central Gateway ECU) D
NG (for RHD without Central Gateway ECU) E



A

2.CHECK ENTRY AND START SYSTEM

B

C

D

E

2.CHECK ENTRY AND START SYSTEM
a.

Check if the entry and start system (for Entry Function) is malfunctioning (See page Vehicle Interior>THEFT DETERRENT / KEYLESS ENTRY>ENTRY AND START SYSTEM(for Entry Function)>HOW TO PROCEED WITH TROUBLESHOOTING).

HINT:

Customization may not be possible depending on the malfunction in the entry and start system (for Entry Function).


OK:

No malfunctions are present in the entry and start system (for Entry Function).




OK

3.CHECK CUSTOMIZE ITEMS

NG

3.CHECK CUSTOMIZE ITEMS
a.

Display the "Vehicle Customization" screen.


b.

Make a note of the customizable items for each certification ECU related system.

HINT:

These items shown as customizable via the multi-display assembly vehicle customization screen can also be changed using the GTS. In a following step, the GTS will be used.


i.

Check the customize parameters list for the entry and start system (for Entry Function) related items that can be customized via the multi-display assembly screen (See page Vehicle Interior>THEFT DETERRENT / KEYLESS ENTRY>ENTRY AND START SYSTEM(for Entry Function)>CUSTOMIZE PARAMETERS).



c.

Manually change and confirm that it was possible to successfully change the settings of the customize parameters for each system that are available for customization via the multi-display assembly screen.

OK:

The items available for customization via the multi-display assembly screen can be customized successfully using the manual procedure.




OK

REPLACE MULTI-MEDIA MODULE RECEIVER ASSEMBLY

NG

REPLACE CERTIFICATION ECU (SMART KEY ECU ASSEMBLY)