Home › Audio / Visual / Telematics › AUDIO / VIDEO › AUDIO AND VISUAL SYSTEM (w/ Multi-display) › from 2015.08
RM2660E _56 Audio / Visual / Telematics _052828 AUDIO / VIDEO _0255488 AUDIO AND VISUAL SYSTEM(w/ Multi-display) J

AUDIO / VIDEO  AUDIO AND VISUAL SYSTEM(w/ Multi-display)  Visual Mute Signal Circuit between Radio Receiver and Multi-display  


DESCRIPTION

The multi-media module receiver assembly sends a visual mute signal to the multi-display assembly. As a result, a black screen is inserted when the screen changes so that noise and distorted images are not displayed.

When an open exists in the circuit, noise and distorted images will be displayed instead of a black screen.

When a short exists in the circuit, even though the multi-display assembly is operating normally, noise and distorted images will be displayed (black screen will not be displayed) during screen changes or the black screen will always be displayed.

WIRING DIAGRAM

E245681E75
1.527,0.912 1.921,1.075 0.394,0.163 10 VMTI 5.252,0.917 5.692,1.080 0.441,0.163 10 VMTF 2.006,0.783 2.185,0.921 0.179,0.139 10 11 5.016,0.787 5.204,0.926 0.188,0.139 10 10 0.951,1.495 1.492,1.651 0.541,0.156 10 F79 5.057,1.48 5.499,1.663 0.441,0.184 10 F77 5.057,1.634 6.530,1.971 1.473,0.336 10 Multi-media Module Receiver Assembly 0.951,1.65 2.422,1.837 1.470,0.187 10 Multi-display Assembly

PROCEDURE

1.CHECK MULTI-MEDIA MODULE RECEIVER ASSEMBLY
a.
U166564E01
0.077,0.007 0.289,0.183 0.212,0.176 10 *a 1.636,0.282 1.907,0.446 0.272,0.164 10 F77 2.277,1.743 2.697,1.926 0.420,0.184 10 VMTF 2.226,1.829 2.094,1.829 2.094,1.829 1.896,1.087 false

Measure the voltage according to the value(s) in the table below.

Standard Voltage:
Tester Connection Condition Specified Condition
F77-10 (VMTF) - Body ground Engine switch on (ACC), screen display changes 3.5 V or higher → Below 1 V → 3.5 V or higher


Text in Illustration
*a Component with harness connected
(Multi-media Module Receiver Assembly)



OK

2.CHECK HARNESS AND CONNECTOR (MULTI-MEDIA MODULE RECEIVER ASSEMBLY - MULTI-DISPLAY ASSEMBLY)

NG

REPLACE MULTI-MEDIA MODULE RECEIVER ASSEMBLY

2.CHECK HARNESS AND CONNECTOR (MULTI-MEDIA MODULE RECEIVER ASSEMBLY - MULTI-DISPLAY ASSEMBLY)
a.

Disconnect the F77 multi-media module receiver assembly connector.


b.

Disconnect the F79 multi-display assembly connector.


c.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
F77-10 (VMTF) - F79-11 (VMTI) Always Below 1 Ω
F77-10 (VMTF) or F79-11 (VMTI) - Body ground Always 10 kΩ or higher




OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR