Home › Audio / Visual / Telematics › NAVIGATION / MULTI INFO DISPLAY › NAVIGATION SYSTEM › from 2015.08
RM2660E _56 Audio / Visual / Telematics _052829 NAVIGATION / MULTI INFO DISPLAY _0255494 NAVIGATION SYSTEM J

NAVIGATION / MULTI INFO DISPLAY  NAVIGATION SYSTEM  Parking Brake Switch Circuit  


DESCRIPTION

This circuit includes the parking brake switch assembly and multi-media module receiver assembly.

WIRING DIAGRAM

E330591E03
2.905,1.934 3.237,2.118 0.332,0.184 10 E53 5.518,1.577 6.127,1.823 0.610,0.246 10 PKB 5.237,1.465 5.569,1.648 0.332,0.184 10 55 3.962,1.465 4.294,1.648 0.332,0.184 10 1 2.905,2.074 4.327,2.445 1.422,0.371 10 Parking Brake Switch Assembly 5.455,2.649 6.245,2.832 0.790,0.184 10 F77 5.462,2.803 6.780,3.181 1.318,0.378 10 Multi-media Module Receiver Assembly

PROCEDURE

1.CHECK VEHICLE SIGNAL (OPERATION CHECK)
a.

b.

Check that the display changes between ON and OFF according to the parking brake operation.

OK:
Parking Brake Condition Display
Applied ON
Released OFF


HINT:

This display is updated once per second. As a result, it is normal for the display to lag behind the actual parking brake operation.




OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE

NG

2.CHECK HARNESS AND CONNECTOR (MULTI-MEDIA MODULE RECEIVER ASSEMBLY - PARKING BRAKE SWITCH ASSEMBLY)
2.CHECK HARNESS AND CONNECTOR (MULTI-MEDIA MODULE RECEIVER ASSEMBLY - PARKING BRAKE SWITCH ASSEMBLY)
a.

Disconnect the F77 multi-media module receiver assembly connector.


b.

Disconnect the E53 parking brake switch assembly connector.


c.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
F77-55 (PKB) - E53-1 Always Below 1 Ω
F77-55 (PKB) - Body ground Always 10 kΩ or higher




OK

3.INSPECT PARKING BRAKE SWITCH ASSEMBLY

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR

3.INSPECT PARKING BRAKE SWITCH ASSEMBLY
a.
E248885

Remove the parking brake switch assembly. (See page Brake>PARKING BRAKE>PARKING BRAKE LEVER>REMOVAL).


b.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Switch Condition Specified Condition
1 - Switch body ON (Shaft not pressed) Below 1 Ω
OFF (Shaft pressed) 10 kΩ or higher


Text in Illustration
V100135

ON
V100136

OFF



OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE

NG

REPLACE PARKING BRAKE SWITCH ASSEMBLY