Home › Audio / Visual / Telematics › NAVIGATION / MULTI INFO DISPLAY › NAVIGATION SYSTEM › from 2015.08
RM2660E _56 Audio / Visual / Telematics _052829 NAVIGATION / MULTI INFO DISPLAY _0255494 NAVIGATION SYSTEM C

NAVIGATION / MULTI INFO DISPLAY  NAVIGATION SYSTEM  B15A0  LAN Master Malfunction  B15AD  Navigation Processor Malfunction  B15B7  Bluetooth Module Malfunction  


DESCRIPTION

These DTCs are stored when a malfunction occurs in the multi-media module receiver assembly.

DTC Code DTC Detection Condition Trouble Area
B15A0 When one of the conditions below is met:
·

Bus malfunction

·

Sub-microprocessor malfunction

·

EEPROM error


Multi-media module receiver assembly
B15AD When either of the conditions below is met:
·

A short to ground, short to +B or open occurs in the gyro signal circuit

·

Gyro sensor malfunction


B15B7 When either of the conditions below is met:
·

Internal IC malfunction

·

Tuner malfunction



CAUTION / NOTICE / HINT

NOTICE:

Depending on the parts that are replaced during vehicle inspection or maintenance, performing initialization, registration or calibration may be needed. Refer to Precaution for Navigation System (See page Audio / Visual / Telematics>NAVIGATION / MULTI INFO DISPLAY>NAVIGATION SYSTEM>PRECAUTION).


PROCEDURE

2.CHECK DTC
a.

Recheck for DTCs and check if the same DTCs are output again (See page Audio / Visual / Telematics>NAVIGATION / MULTI INFO DISPLAY>NAVIGATION SYSTEM>DTC CHECK / CLEAR).

OK:

No DTCs are output.




OK

NG

REPLACE MULTI-MEDIA MODULE RECEIVER ASSEMBLY