Home › Audio / Visual / Telematics › NAVIGATION / MULTI INFO DISPLAY › NAVIGATION SYSTEM › from 2015.08
RM2660E _56 Audio / Visual / Telematics _052829 NAVIGATION / MULTI INFO DISPLAY _0255494 NAVIGATION SYSTEM C

NAVIGATION / MULTI INFO DISPLAY  NAVIGATION SYSTEM  B15F7  Certification ECU Vehicle Information Reading/Writing Process Malfunction  


DESCRIPTION

This DTC is stored when items controlled by the certification ECU cannot be customized via the navigation system vehicle customization screen.

HINT:

The certification ECU controls the entry and start system (for Entry Function) related items that are customizable via the multi-display assembly screen.


DTC Code DTC Detection Condition Trouble Area
B15F7 Certification ECU vehicle setting processing error.
·

CAN communication system

·

Entry and start system (for Entry Function)

·

Certification ECU

·

Multi-media module receiver assembly



CAUTION / NOTICE / HINT

NOTICE:

Depending on the parts that are replaced during vehicle inspection or maintenance, performing initialization, registration or calibration may be needed. Refer to Precaution for Navigation System (See page Audio / Visual / Telematics>NAVIGATION / MULTI INFO DISPLAY>NAVIGATION SYSTEM>PRECAUTION).


PROCEDURE

1.CHECK CAN COMMUNICATION SYSTEM
a.

Use the GTS to check if the CAN communication system is functioning normally.


OK:

CAN communication DTCs are not output.


Result
Result Proceed to
OK A
NG (for LHD) B
NG (for RHD) C



A

2.CHECK ENTRY AND START SYSTEM (for Entry Function)

B

C

2.CHECK ENTRY AND START SYSTEM (for Entry Function)
a.

Check if the entry and start system (for Entry Function) is malfunctioning (See page Vehicle Interior>THEFT DETERRENT / KEYLESS ENTRY>ENTRY AND START SYSTEM(for Entry Function)>HOW TO PROCEED WITH TROUBLESHOOTING).

HINT:

Customization may not be possible depending on the malfunction in the entry and start system.


OK:

No malfunctions are present in the entry and start system.




OK

3.CHECK CUSTOMIZE ITEMS

NG

3.CHECK CUSTOMIZE ITEMS
a.

Display the "Vehicle Customization" screen.


b.

Make a note of the customizable items for each certification ECU related system.

HINT:

These items shown as customizable via the navigation system vehicle customization screen can also be changed manually. In a following step, a manual procedure will be used.


i.

Check the customize parameters list for the entry and start system related items that can be customized via the multi-display assembly screen (See page Vehicle Interior>THEFT DETERRENT / KEYLESS ENTRY>ENTRY AND START SYSTEM(for Entry Function)>CUSTOMIZE PARAMETERS).



c.

Manually change and confirm that it was possible to successfully change the settings of the customize parameters for each system that are available for customization via the multi-display assembly screen.

OK:

The items available for customization via the multi-display assembly screen can be customized successfully using the manual procedure.




OK

REPLACE MULTI-MEDIA MODULE RECEIVER ASSEMBLY

NG

REPLACE CERTIFICATION ECU