Home › Audio / Visual / Telematics › NAVIGATION / MULTI INFO DISPLAY › NAVIGATION SYSTEM › 2014.08–2015.08
RM2660E _56 Audio / Visual / Telematics _052829 NAVIGATION / MULTI INFO DISPLAY _0255494 NAVIGATION SYSTEM C

NAVIGATION / MULTI INFO DISPLAY  NAVIGATION SYSTEM  B1574  GVIF Disconnected (from Park Assist/Monitoring ECU to EMV/MM Integrated Device)  


DESCRIPTION

DTC Code DTC Detection Condition Trouble Area
B1574 GVIF disconnected (from Parking assist ECU to Multi-display)
·

Harness or connector (GVIF cable)

·

Multi-display assembly



PROCEDURE

2.CHECK DTC
a.

Recheck for DTCs and check if the same DTC is output again (See page Audio / Visual / Telematics>NAVIGATION / MULTI INFO DISPLAY>NAVIGATION SYSTEM>DTC CHECK / CLEAR).

OK:

No DTCs are output.




OK

NG

3.CHECK HARNESS AND CONNECTOR (GVIF CABLE)
3.CHECK HARNESS AND CONNECTOR (GVIF CABLE)
a.

Check that the digital signal lines between the multi-display assembly and parking assist ECU are not sharply bent or pinched, and that the connectors are properly connected and there are no other installation problems.

OK:

There are no installation problems.




OK

4.REPLACE HARNESS AND CONNECTOR (GVIF CABLE)

NG

REPLACE HARNESS AND CONNECTOR (GVIF CABLE)

4.REPLACE HARNESS AND CONNECTOR (GVIF CABLE)
a.

Replace the harness and connector (GVIF cable) with a new or normally functioning one.



NEXT

5.CLEAR DTC
6.CHECK DTC
a.

Recheck for DTCs and check if the same DTC is output again (See page Audio / Visual / Telematics>NAVIGATION / MULTI INFO DISPLAY>NAVIGATION SYSTEM>DTC CHECK / CLEAR).

OK:

No DTCs are output.




OK

END (GVIF CABLE IS DEFECTIVE)

NG