1. PRECAUTION
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).
2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).
55510F
3.REMOVE NO. 1 SPEAKER OPENING COVER ASSEMBLY
55670
4.REMOVE NO. 3 INSTRUMENT PANEL REGISTER ASSEMBLY
55680A
5.REMOVE NO. 4 INSTRUMENT PANEL REGISTER ASSEMBLY
86110B
6.REMOVE MULTI-DISPLAY ASSEMBLY
Remove the 2 screws and 2 bolts.
Pull the multi-display assembly to detach the 2 clips and 6 claws on the backside of the multi-display assembly.
Disconnect the connectors and remove the multi-display assembly.
86211J
7.REMOVE NO. 1 RADIO RECEIVER BRACKET
Remove the 4 bolts and No. 1 radio receiver bracket.