The multi-media module receiver assembly stores this DTC when the SD card cannot be mounted when inserted into the SD card slot.
| DTC Code | DTC Detection Condition | Trouble Area |
|---|---|---|
| B158C | The SD card cannot be mounted when inserted into the SD card slot. | ·
SD card ·
Multi-media module receiver assembly |
Depending on the parts that are replaced during vehicle inspection or maintenance, performing initialization, registration or calibration may be needed. Refer to Precaution for Navigation System (See page Audio / Visual / Telematics>NAVIGATION / MULTI INFO DISPLAY>NAVIGATION SYSTEM>PRECAUTION).
Turn the engine switch off and remove the SD card from the SD card slot.
Check that the SD card is not damaged.
The SD card is not damaged.
OK
NG
Check that the terminals of the SD card are free of foreign matter. Remove foreign matter as necessary.
Check that the SD card slot of the multi-media module receiver assembly is free of foreign matter. Remove foreign matter as necessary.
Insert the SD card into the SD card slot.
NEXT
Clear the DTCs (See page Audio / Visual / Telematics>NAVIGATION / MULTI INFO DISPLAY>NAVIGATION SYSTEM>DTC CHECK / CLEAR).
Recheck for DTCs and check if the same DTC is output again (See page Audio / Visual / Telematics>NAVIGATION / MULTI INFO DISPLAY>NAVIGATION SYSTEM>DTC CHECK / CLEAR).
No DTCs are output.
OK
NG
Replace the SD card.
Clear the DTCs (See page Audio / Visual / Telematics>NAVIGATION / MULTI INFO DISPLAY>NAVIGATION SYSTEM>DTC CHECK / CLEAR).
Recheck for DTCs and check if the same DTC is output again (See page Audio / Visual / Telematics>NAVIGATION / MULTI INFO DISPLAY>NAVIGATION SYSTEM>DTC CHECK / CLEAR).
No DTCs are output.
OK
NG