Home › Audio / Visual / Telematics › NAVIGATION / MULTI INFO DISPLAY › NAVIGATION SYSTEM › 2014.08–2015.08
RM2660E _56 Audio / Visual / Telematics _052829 NAVIGATION / MULTI INFO DISPLAY _0255494 NAVIGATION SYSTEM C

NAVIGATION / MULTI INFO DISPLAY  NAVIGATION SYSTEM  B1575  GVIF Disconnected (from EMV/MM Integrated Device to Multi Display)  


DESCRIPTION

DTC Code DTC Detection Condition Trouble Area
B1575 GVIF disconnected (from Multi-media module receiver assembly to Multi-display assembly)
·

Harness or connector (GVIF cable)

·

Multi-media module receiver assembly



PROCEDURE

2.CHECK DTC
a.

Recheck for DTCs and check if the same DTC is output again (See page Audio / Visual / Telematics>NAVIGATION / MULTI INFO DISPLAY>NAVIGATION SYSTEM>DTC CHECK / CLEAR).

OK:

No DTCs are output.




OK

NG

3.CHECK HARNESS AND CONNECTOR (GVIF CABLE)
3.CHECK HARNESS AND CONNECTOR (GVIF CABLE)
a.

Check that the digital signal lines between the multi-display assembly and parking assist ECU are not sharply bent or pinched, and that the connectors are properly connected and there are no other installation problems.

OK:

There are no installation problems.




OK

4.REPLACE HARNESS AND CONNECTOR (GVIF CABLE)

NG

REPLACE HARNESS AND CONNECTOR (GVIF CABLE)

4.REPLACE HARNESS AND CONNECTOR (GVIF CABLE)
a.

Replace the harness and connector (GVIF cable) with a new or normally functioning one.



NEXT

5.CLEAR DTC
6.CHECK DTC
a.

Recheck for DTCs and check if the same DTC is output again (See page Audio / Visual / Telematics>NAVIGATION / MULTI INFO DISPLAY>NAVIGATION SYSTEM>DTC CHECK / CLEAR).

OK:

No DTCs are output.




OK

END (GVIF CABLE IS DEFECTIVE)

NG

REPLACE MULTI-MEDIA MODULE RECEIVER ASSEMBLY