| DTC Code | DTC Detection Condition | Trouble Area |
|---|---|---|
| B1575 | GVIF disconnected (from Multi-media module receiver assembly to multi-display assembly) | ·
Harness or connector (GVIF cable) ·
Multi-media module receiver assembly |
Depending on the parts that are replaced during vehicle inspection or maintenance, performing initialization, registration or calibration may be needed. Refer to Precaution for Navigation System (See page Audio / Visual / Telematics>NAVIGATION / MULTI INFO DISPLAY>NAVIGATION SYSTEM>PRECAUTION).
Clear the DTCs (See page Audio / Visual / Telematics>NAVIGATION / MULTI INFO DISPLAY>NAVIGATION SYSTEM>DTC CHECK / CLEAR).
NEXT
Recheck for DTCs and check if the same DTC is output again (See page Audio / Visual / Telematics>NAVIGATION / MULTI INFO DISPLAY>NAVIGATION SYSTEM>DTC CHECK / CLEAR).
No DTCs are output.
OK
(See pageGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING)
NG
Check that the digital signal lines between the multi-display assembly and multi-media module receiver assembly are not sharply bent or pinched, and that the connectors are properly connected and there are no other installation problems.
There are no installation problems.
OK
NG
Disconnect the F108 multi-display assembly connector.
Disconnect the F107 multi-media module receiver assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| F108-1 (GV+) - F107-1 (GVI+) | Always | Below 1 Ω |
| F108-2 (GV-) - F107-2 (GVI-) | Always | Below 1 Ω |
| F108-3 (GVG) - F107-3 (GVG1) | Always | Below 1 Ω |
| F108-1 (GV+) - Body ground | Always | 10 kΩ or higher |
| F108-2 (GV-) - Body ground | Always | 10 kΩ or higher |
| F108-3 (GVG) - Body ground | Always | 10 kΩ or higher |
| *a | Front view or wire harness connector
(to Multi-media Module Receiver Assembly) |
| *b | Front view or wire harness connector
(to Multi-display Assembly) |
OK
NG