The No. 1 ultrasonic sensor (RL sensor) is installed on the rear bumper. The ECU detects obstacles based on signals received from the No. 1 ultrasonic sensor (RL sensor). If the No. 1 ultrasonic sensor (RL sensor) has an open circuit or other malfunction, it will not function normally.
| DTC Code | DTC Detection Condition | Trouble Area |
|---|---|---|
| C1AE6 | A malfunction of the No. 1 ultrasonic sensor (RL sensor). | ·
No. 1 ultrasonic sensor (RL sensor) ·
Parking assist ECU*1 ·
Clearance warning ECU assembly*2 |
*1: w/ Side Monitor System
*2: w/o Side Monitor System
If the DTC is output after repairs, turn the engine switch on (IG) and move the shift lever to R. Then clear the DTC.
Clear the DTCs (See page Audio / Visual / Telematics>PARK ASSIST / MONITORING>TOYOTA PARKING ASSIST-SENSOR SYSTEM>DTC CHECK / CLEAR).
Check for DTCs (See page Audio / Visual / Telematics>PARK ASSIST / MONITORING>TOYOTA PARKING ASSIST-SENSOR SYSTEM>DTC CHECK / CLEAR).
DTC C1AE6 is not output.
OK
(See pageGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING)
NG
Replace the No. 1 ultrasonic sensor (RL sensor) with a normally functioning one (See page Audio / Visual / Telematics>PARK ASSIST / MONITORING>ULTRASONIC SENSOR (for Rear)>REMOVAL).
NEXT
Clear the DTCs (See page Audio / Visual / Telematics>PARK ASSIST / MONITORING>TOYOTA PARKING ASSIST-SENSOR SYSTEM>DTC CHECK / CLEAR).
Check for DTCs (See page Audio / Visual / Telematics>PARK ASSIST / MONITORING>TOYOTA PARKING ASSIST-SENSOR SYSTEM>DTC CHECK / CLEAR).
| Result | Proceed to |
|---|---|
| DTC C1AE6 is not output | A |
| DTC C1AE6 is output (w/ Side Monitor System) | B |
| DTC C1AE6 is output (w/o Side Monitor System) | C |
A
B
C