52159
1.REMOVE REAR BUMPER COVER
for Standard:
(See page Vehicle Exterior>EXTERIOR PANELS / TRIM>REAR BUMPER(for Standard)>REMOVAL).
w/ Towing Hitch:
(See page Vehicle Exterior>EXTERIOR PANELS / TRIM>REAR BUMPER (w/ Towing Hitch)>REMOVAL).
w/ Pintle Hook:
(See page Vehicle Exterior>EXTERIOR PANELS / TRIM>REAR BUMPER(w/ Pintle Hook)>REMOVAL).
82165
2.REMOVE NO. 2 FRAME WIRE
for Standard:
(See page Vehicle Exterior>EXTERIOR PANELS / TRIM>REAR BUMPER(for Standard)>DISASSEMBLY).
w/ Towing Hitch:
(See page Vehicle Exterior>EXTERIOR PANELS / TRIM>REAR BUMPER (w/ Towing Hitch)>DISASSEMBLY).
w/ Pintle Hook:
(See page Vehicle Exterior>EXTERIOR PANELS / TRIM>REAR BUMPER(w/ Pintle Hook)>DISASSEMBLY).
89341A
3.REMOVE NO. 1 ULTRASONIC SENSOR
Detach the 2 claws and remove the No. 1 ultrasonic sensor.
Use the same procedure for all No. 1 ultrasonic sensors.
The illustration shows the No. 1 ultrasonic sensor for the RH corner and back sensor LH and RH. The installation position of the No. 1 ultrasonic sensor for the LH corner is on the opposite side.
89348
4.REMOVE NO. 1 ULTRASONIC SENSOR RETAINER
Detach the 2 claws and remove the No. 1 ultrasonic sensor retainer from the rear bumper cover.
Use the same procedure to remove the No. 1 ultrasonic sensor retainer on the other side.
The illustration shows the No. 1 ultrasonic sensor retainer for the RH corner. The vertical orientation of the No. 1 ultrasonic sensor retainers for the LH corner is opposite that of the image shown in the illustration.
89348A
5.REMOVE NO. 2 ULTRASONIC SENSOR RETAINER
Detach the 2 claws and remove the No. 2 ultrasonic sensor retainer from the rear bumper cover.
Use the same procedure to remove the No. 2 ultrasonic sensor retainer on the other side.