52119A
1.REMOVE FRONT BUMPER COVER
82114
2.REMOVE NO. 4 ENGINE ROOM WIRE
89348D
3.REMOVE ULTRASONIC SENSOR CLIP
Detach the 4 claws and remove the ultrasonic sensor clip.
89341A
4.REMOVE NO. 1 ULTRASONIC SENSOR
Use the same procedure to remove the No. 1 ultrasonic sensor on the other side.
While pushing down on the lever with a finger to release the one claw, detach the claw on the other side to remove the No. 1 ultrasonic sensor.
The type of claw on the top and bottom of the sensor are different. Observe the claws carefully before removing the No. 1 ultrasonic sensor.
89348A
5.REMOVE NO. 2 ULTRASONIC SENSOR RETAINER
Use the same procedure to remove the No. 2 ultrasonic sensor retainer on the other side.
Detach the 2 claws and remove the No. 2 ultrasonic sensor retainer from the front bumper cover.