52119A
1.REMOVE FRONT BUMPER COVER
for Standard:
(See page Vehicle Exterior>EXTERIOR PANELS / TRIM>FRONT BUMPER(for Standard)>REMOVAL)
for Winch:
(See page Vehicle Exterior>EXTERIOR PANELS / TRIM>FRONT BUMPER(w/ Winch)>REMOVAL)
89347B
2.REMOVE FRONT CORNER ULTRASONIC SENSOR RETAINER (w/ Front Corner Ultrasonic Sensor Retainer)
Detach the 2 claws and remove the front corner ultrasonic sensor retainer.
|
Remove in this Direction | - | - |
|
Do not Apply Pressure |
Do not apply pressure to the part shown in the illustration. Otherwise, the sensor may be damaged.
89341A
3.REMOVE NO. 1 ULTRASONIC SENSOR
Use the same procedure for both No. 1 ultrasonic sensors.
Disconnect the 2 connectors.
Detach the claw and remove the No. 1 ultrasonic sensor as shown in the illustration.