w/ Dynamic Radar Cruise Control System:
When the front bumper is damaged or deformed due to an accident or contact with other objects, etc., or the bumper installation area on the body is repaired, it is necessary to perform millimeter wave radar sensor adjustment.
Click hereEngine / Hybrid System>CRUISE CONTROL>MILLIMETER WAVE RADAR SENSOR>ADJUSTMENT
53806
1.REMOVE FRONT FENDER SPLASH SHIELD SUB-ASSEMBLY LH
Remove the 3 bolts and screw.
Turn the clip indicated by the arrow in the illustration to remove the front fender splash shield sub-assembly LH.
53805
2.REMOVE FRONT FENDER SPLASH SHIELD SUB-ASSEMBLY RH
Remove the 3 bolts and 2 screws.
Turn the clip indicated by the arrow in the illustration to remove the front fender splash shield sub-assembly RH.
52049
3.REMOVE FRONT BUMPER WINCH COVER SUB-ASSEMBLY
Put protective tape around the front bumper winch cover sub-assembly.
| *a | Protective Tape |
Using moulding remover A, detach the 2 claws.
Detach the 2 guides and remove the front bumper winch cover sub-assembly as shown in the illustration.
53292A
4.REMOVE UPPER RADIATOR SUPPORT SEAL
Remove the 7 clips and upper radiator support seal.
| *A | for Gasoline |
| *B | for Diesel |
53182
5.REMOVE HEADLIGHT COVER LH (w/ Headlight Cover)
Put protective tape around the headlight cover LH.
| *a | Protective Tape |
Detach the 5 claws and remove the headlight cover LH.
53181
6.REMOVE HEADLIGHT COVER RH (w/ Headlight Cover)
Use the same procedure described for the LH side.
52119A
7.REMOVE FRONT BUMPER COVER
Using a T30 "TORX" socket, remove the 3 screws.
Use the same procedure for the other side.
Remove the 2 screws and 4 bolts.
Remove the 3 screws.
Remove the 3 clips.
Put protective tape around the front bumper cover.
Use the same procedure for the other side.
| *a | Protective Tape |
Detach the 3 claws.
Use the same procedure for the other side.
Remove the front bumper cover.
Disconnect the winch control wire connector.
w/ Fog Light:
Disconnect the No. 4 engine room wire connector.
w/ Multi-terrain Monitor:
Disconnect the connector.
w/ Dynamic Radar Cruise Control System:
Disconnect the connector.
52113D
8.REMOVE FRONT BUMPER EXTENSION LH
Remove the 3 bolts and front bumper extension LH.
52112D
9.REMOVE FRONT BUMPER EXTENSION RH
Use the same procedure described for the LH side.
52116A
10.REMOVE FRONT BUMPER SIDE SUPPORT LH
Remove the 2 screws.
Detach the 3 claws and remove the front bumper side support LH.
52115A
11.REMOVE FRONT BUMPER SIDE SUPPORT RH
Use the same procedure described for the LH side.
81150
12.REMOVE HEADLIGHT ASSEMBLY LH
for Halogen Headlight:
(See page Vehicle Exterior>LIGHTING (EXT)>HEADLIGHT ASSEMBLY (for Halogen Headlight)>REMOVAL)
for LED Headlight:
(See page Vehicle Exterior>LIGHTING (EXT)>HEADLIGHT ASSEMBLY(for LED Headlight)>REMOVAL)
for Halogen Headlight and LED Headlight:
(See page Vehicle Exterior>LIGHTING (EXT)>HEADLIGHT ASSEMBLY(for Halogen Headlight and LED Headlight)>REMOVAL)
81110
13.REMOVE HEADLIGHT ASSEMBLY RH
Use the same procedure described for the LH side.
52521
14.REMOVE FRONT BUMPER UPPER CENTER RETAINER
Remove the 3 bolts.
Detach the guide and remove the front bumper upper center retainer.