Home › Audio / Visual / Telematics › PARK ASSIST / MONITORING › ULTRASONIC SENSOR (for Rear) › from 2015.08
RM2660E _56 Audio / Visual / Telematics _052831 PARK ASSIST / MONITORING _0255503 ULTRASONIC SENSOR(for Rear) A

PARK ASSIST / MONITORING  ULTRASONIC SENSOR(for Rear)  INSTALLATION  


PROCEDURE

Hide 89341B 1.INSTALL NO. 2 ULTRASONIC SENSOR

HINT:

Use the same procedure for both No. 2 ultrasonic sensors.


a.

Attach the claw as shown in the illustration to install the No. 2 ultrasonic sensor.

NOTICE:
·

Be careful of connector direction when inserting the sensor connector.

·

Do not damage the bumper when inserting the sensor connector.



B354822


b.

Connect the 4 connectors.

NOTICE:
·

Push the sensor perpendicularly to the bumper with the palm of the hand.

·

Pay attention not to damage the sensor.

·

Approach the wire harness connector straight to the sensor connector.



HINT:
·

When connecting the wire harness to the sonar sensor, hold the sensor from bumper surface.

·

After connecting the wire harness to the sonar sensor, push the sensor from the bumper surface.

B428680