Home › Audio / Visual / Telematics › PARK ASSIST / MONITORING › PARKING ASSIST MONITOR SYSTEM(w/o Side Monitor System) › 2014.08–2015.08
RM2660E _56 Audio / Visual / Telematics _052831 PARK ASSIST / MONITORING _0255506 PARKING ASSIST MONITOR SYSTEM(w/o Side Monitor System) C

PARK ASSIST / MONITORING  PARKING ASSIST MONITOR SYSTEM(w/o Side Monitor System)  C1691  Back Camera Initialization Incomplete  


SYSTEM DESCRIPTION

This DTC is stored when the multi-media module receiver assembly judges that the back camera initial setting has not been memorized (rear television camera optical axis adjustment is incomplete).

DTC Code DTC Detection Condition Trouble Area
C1691 Back camera initial setting has not been memorized
·

Rear television camera optical axis adjustment

·

Multi-media module receiver assembly



CAUTION / NOTICE / HINT

NOTICE:
·

When "System initializing" is displayed on the multi-media module receiver assembly after disconnecting the cable from the negative (-) battery terminal, correct the steering angle neutral point (See page Audio / Visual / Telematics>PARK ASSIST / MONITORING>PARKING ASSIST MONITOR SYSTEM(w/o Side Monitor System)>INITIALIZATION).

·

Depending on the parts that are replaced or operations that are performed during vehicle inspection or maintenance, calibration of other systems as well as the parking assist monitor system (w/o Side Monitor System) may be needed (See page Audio / Visual / Telematics>PARK ASSIST / MONITORING>PARKING ASSIST MONITOR SYSTEM(w/o Side Monitor System)>CALIBRATION).



PROCEDURE

1.ADJUST SETTINGS
a.

Perform the following procedure depending on the memory conditions to register the vehicle information into the multi-media module receiver assembly.




NEXT

2.CHECK FOR DTC
2.CHECK FOR DTC

b.

Check for DTCs (See page Audio / Visual / Telematics>PARK ASSIST / MONITORING>PARKING ASSIST MONITOR SYSTEM(w/o Side Monitor System)>DTC CHECK / CLEAR).

OK:

DTC C1691 is not output.


HINT:
·

If DTC C1691 is output, perform the rear television camera assembly optical axis adjustment again.

·

If DTC C1691 is still output after performing the rear television camera assembly optical axis adjustment 3 times, replace the multi-media module receiver assembly.





OK

END (REAR TELEVISION CAMERA OPTICAL AXIS ADJUSTMENT IS DEFECTIVE)

NG

REPLACE MULTI-MEDIA MODULE RECEIVER ASSEMBLY